Profi Cook PC-AE 1156 - Инструкция по эксплуатации - Страница 38

PC-AE1156_IM 

07.06.18

38

Speed Levels

Press the   button repeatedly to select the desired speed 

level:

Tomato, Melon

Celery, Citrus Fruits, Cucumber

Apple, Pear, Peach

Carrot, Garlic, Beet

Pomegranate, Potato

 NOTE:

During operation, the speed level can not be changed. 

When pressing the   button the motor will switch off 

automatically.

Extracting Juice

 NOTE:

• 

The appliance is intended for short-term use. Stop the 

appliance for 1 minute after operating for 3 minutes.

• 

You can enter a pulse mode by pressing the Pulse

button. Press the button shortly, then release it again.

 WARNING:

Check all accessories again for proper attachment before 

switching the appliance on.

1. 

Turn the appliance on by using the   button. The 

display and buttons light up. The middle speed level ( 

 ) 

appears in the display.

2.  Select the desired speed level by pressing the   button.

3.  Start the motor by pressing the 

Start

 button.

4. 

Insert the fruit pieces in the filler opening and push them 

down with the tamper. Please note! The tamper has a 

guide way in the filler opening.

5. 

The juice flows out at the right side of the housing. The 

pulp is collected in the pulp container. If the discharge 

of juice is greatly increased, select a lower speed level. 

Start the motor again by pressing the 

Start

 button. Apply 

less pressure with the tamper.

 NOTE:

•  Observe the juice jug. Stop operation in time to prevent 

overflowing.

•  Berries and citrus fruits (such as gooseberries, grapes, 

oranges) are usually not juiced but pressed.

•  When juicing these fruits with their high juice content, 

splashing of juice from the area of the pulp container 

may occur. In this case, we recommend that the pulp 

container is emptied more frequently.

Stop Operation and Disassembly

1.  Press the 

Start

 button to switch off the motor.

2. 

Then switch the appliance into standby mode using the 

 button.

3.  Disconnect from mains power supply.

4.  Put the juice jug aside and open both of the closures.

5.  Remove the transparent cover.

6.  Remove the pulp container. 

7.  Remove the centrifugal sieve with the centrifuge 

housing. You can do this by reaching under the flange of 

the centrifugal housing and under the spout. Move the 

centrifugal housing up alternately on each side. Remove 

it by pulling it gradually upwards. If necessary, press 

down the base appliance using the ring fingers and 

small fingers.

8. 

   WARNING: Risk of Cuts!

The centrifugal sieve has sharp knives!

Only lift it on its outer edge.

Lift the centrifugal sieve out of the centrifuge housing.

9.  Place the skimmer into the juice jug. Pay attention to the 

guides in the juice jug. This prevents spilling the foam 

while pouring out the juice.

Cleaning

 WARNING:

•  Before cleaning always disconnect from mains power supply.

• 

Never immerse the motor housing in water. This can lead to 

electric shock or fire.

• 

The centrifuge sieve is very sharp! Risk of injury!