Metabo PowerMaxx SSD 600093890 - Инструкция по эксплуатации - Страница 9

ENGLISH

en

9

Causes and remedies:

1.

Battery pack almost flat

 (the electronics 

prevent the battery pack from discharging totally 

and avoid irreparable damage).

If the battery pack is almost flat, it must be 

recharged.

2. Long continuous overloading of the machine will 

activate the 

temperature cut-out

.

Leave the machine or battery pack to cool. 
Note: The machine will cool more quickly if you 

operate it at idling speed.

6.2

Battery pack

Charge the battery pack before use.
If performance diminishes, recharge the battery 

pack.

Removing the battery pack

Press the battery pack release button (6) and 

remove the battery pack (7).

To fit

Slide in the battery pack (7) until it engages.

6.3 Setting the direction of rotation, 

engaging the transporting safety device 

(switch-on lock)

Do not actuate the rotation selector switch or 

engage the transportation lock (4) unless the 

motor has stopped completely!
Actuate the rotational direction switch / 

Engage the transportation lock (4)

R

= Right rotation set 

(insert screws)

L

= Left rotation set 

(remove screws)

0

= Central position: transportation lock setting

(switch-on lock)

6.4 Switching on and off

To switch on:

 press the trigger switch (5).

Switching off

: Release the trigger (5).

6.5 Speed / Tightening torque

The speed and tightening torque are connected 

directly. The lower the speed, the lower the 

tightening torque.
Stepless adjustment of the tightening torque:
The speed and tightening torque can be adjusted 

steplessly by pressing the trigger (5) firmly or lightly, 

thus adapting to working conditions.

Recommendation:

 determine the correct setting 

by carrying out trial screwdriving. 

6.6 Changing screwdriver bit

Inserting screwdriving bit: 

Slide locking sleeve  

(2) forward and insert screwdriving bit as far as the 

stop. Release locking sleeve (2). 

Pull on the screwdriver bit to check that it is 

correctly seated.

Removing screwdriving bit: 

Slide locking sleeve  

(2) forward and remove screwdriving bit. 

Only use screwdriving bits with such plug-in 

ends:

The screwdriving bit used must match the 

screw.
Damaged screwdriving bits must not be used.

Mount the machine on the screw, ensuring it is 

aligned straight. 
The screwdriving process has two elements: 

inserting the screw

 and 

tightening the screw with the percussion 

mechanism.

The tightening torque depends on the impact 

duration.

With an impact duration of approx. 5 seconds, the 

maximum tightening torque has been reached.
The torque curve depends on the type of 

application:
With a hard screwdriving application (screw-

couplings in hard material such as metal), maximum 

tightening torque is already reached after a short 

impact duration (a).
With a soft screwdriving application (screw-

couplings in soft material such as wood), a longer 

impact duration (b) is required.
Recommendation: determine the correct impact 

duration by carrying out trial screwdriving. 

Caution!

 With 

small screws, 

maximum torque can 

be reached even below an impact duration of 0.5 

seconds.
- This is why the duration of the screwdriving 

process must be monitored exactly. 

- Adjust the tightening torque by pressing firmly or 

lightly on the trigger (5), ensuring that the screw is 

not damaged or that the screw head does not tear 

off.

Use only genuine Metabo accessories.

7. Use

8. Accessories