GRAPHITE Energy+ 58g000 - Инструкция по эксплуатации - Страница 21

21

Ɣ

Put an Allen key in the chuck and gently tap the other end of the key.

Ɣ

Unscrew the chuck.

Ɣ

In order to install the chuck, perform the above actions in a reverse order.

Any and all defects must be removed by service companies authorized by the manufacturer.

TECHNICAL PARAMETERS

RATING DATA

Cordless drill/driver

Parameter

Value

Battery voltage

14,4 V DC

Battery type

Li-Ion

Battery capacity

2000 mAh

Range of rotational speed in the idle gear

0-400/0-1100 min

-1

Range of chuck

1-13 mm

Range of torque control

1-20 plus drilling

Max. torque (soft drive)

34 Nm

Max. torque (hard drive)

55 Nm

Protection class

III

Weight

1,52 kg 

Year of manufacture

2017

Charger

Parameter

Value

Supply voltage

230 V AC

Supply current frequency

50 Hz

Charging voltage

17,5 V DC

Max. charging current

2500 mA

Charging time 

1 h

Protection class

II

Weight

0,58 kg

Year of manufacture

2017

NOISE AND VIBRATIONS DATA

Information on noise and vibrations

The emitted noise levels, such as the level of emitted acoustic pressure Lp

A

 and the level of acoustic power 

Lw

A

, and the measurement uncertainty K are given below in the instruction in accordance with the EN 

60745 standard. 
The vibration values a

h

 and the measurement uncertainty K, determined in accordance with the EN 60745 

standard, are given below.
The vibration level given below in this instruction was measured in accordance with a measurement 
procedure set forth in the EN 60745 standard and can be used for comparing power tools. It can also be 
used for preliminary evaluation of exposure to vibrations. 
The vibration level given here is representative for the basic uses of the power tool. If the power tool is 
used for other purposes or with other bits, or if the power tool is not maintained properly, the vibration 
level may change. Also, these conditions may also result in an increased exposure to vibrations during the 
entire work period. 
In order to accurately estimate exposure to vibrations, one must consider periods when the power tool 
is switched off or when it is switched on and not used for work. This way, the total exposure to vibrations