Fein ASCM 18 QM Select 71161164000 - Инструкция по эксплуатации - Страница 21

21

en

Electronic torque shut-off (see pages 9 – 10).

Adjust the torque only when the machine is at a complete 
stop.
The motor switches off when reaching the set torque and 
an audio signal sounds. After the shut-off has taken place, 
release the on/off switch and press it again for the next 
screwdriving operation.
The audio signal can be switched on and off.
The electronic shut-off is deactivated when working in 
the “

” torque level.

To achieve good working results, press the power tool 
with sufficient force against the screw.
The maximum speed is reduced in the lower torque lev-
els.

Handling the battery.

Operate and charge the battery only within the battery 
operating-temperature range of 0 °C – 45 °C (32 °F –
113 °F). At the beginning of the charging procedure, the 
battery temperature must be within the battery operat-
ing-temperature range.

The real percentage of the battery charge condition is 
only indicated when the power tool motor is stopped.
The electronics automatically switch off the motor prior 
to the battery being deep discharged.

Repair and customer service.

When working metal under extreme operat-
ing conditions, it is possible for conductive 
dust to settle in the interior of the power tool. 

Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air. 
The current spare parts list for this power tool can be 
found in the Internet at www.fein.com.

If required, you can change the following parts yourself:

application tools, battery

Warranty and liability.

The warranty for the product is valid in accordance with 
the legal regulations in the country where it is marketed. 
In addition, FEIN also provides a guarantee in accordance 
with the FEIN manufacturer’s warranty declaration.
The delivery scope of your power tool may include only 
a part of the accessories described or shown in this 
Instruction Manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product 
conforming with the relevant provisions given on the last 
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, 
C-DB_IA, D-73529 Schwäbisch Gmünd

Environmental protection, disposal.

Packaging, worn out power tools and accessories should 
be sorted for environmental-friendly recycling.
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insulate 
the terminals with tape as a protective measure against 
short-circuiting.

LED indicator

Meaning

Activity

1 – 4 green 
LED

Percentage of 
charge condi-
tion

Operation

Continuous 
red light

Battery is 
almost empty

Charge battery

Red flashing 
light

Battery is not 
ready for 
operation

Bring the battery into 
the battery operating-
temperature range, 
then charge

OBJ_BUCH-0000000268-001.book  Page 21  Thursday, December 22, 2016  11:31 AM