DENZEL EM-1-1220 27903 - Инструкция по эксплуатации - Страница 6

6

CONSTRUCTION ELECTRIC HAND MIXER   

EN

e)  Check an electric tool regularly. Check alignment accuracy and ease of movement of moving parts, integrity of 

parts and any other elements of the electric tool affecting its work. Do not use a broken electric tool until it is 
completely repaired. Most accidents are the result of insufficient maintenance of the electric tool.

f)  Watch out for sharpness and cleanness of cutting accessories. Sharp-edged accessories allow avoiding jamming 

and make work less tiring.

g)  Use electric tool and accessories in accordance with this manual and taking into account the working conditions 

and nature of future work. Misuse of the electric tool can create a hazardous situation.

Maintenance

Your electric tool must be repaired only by qualified specialists using original spare parts. This will ensure safety 
and reliability of your electric tool in further use. 

Additional security measures for Electric Hand Mixers

a)  Hold the mixer firmly in both hands when working. If this rule is not followed, the operation of the power tool 

becomes dangerous.

b)  It is prohibited to mix solvents and products containing solvents, since there is a risk of ignition at temperatures 

above 21 °C.

с)  Hold electrical cable away from the rotating working tool. If you lose control of your electric tool, the power cord 

may be cut or captured by a rotating working tool.

d)  When jamming the paddle immediately turn off the mixer. 
e)  Turn the machine on and off only inside the tank with mixed composition, the immobility of which must be 

ensured.

f)  It is prohibited to put hands into the tank with mixture while working. To avoid equipment breakages do not 

put any objects into the tank.

g)  During operation immerse the working part of the machine in mixed composition at low speed of rotation of 

the paddle in order to avoid splashing of the mixed composition. It is recommended to increase the rotation 
speed to the maximum for better engine cooling when the paddles are completely immersed in the mixed 
composition. It is recommended to remove the working part of the machine from the mixed composition at 
minimum speed.

h)  The machine can be released from the hands only after complete stop.
i)  Keep the engine in good condition. In case of failure, appearance of suspicious odors characteristic of burning 

insulation, strong noise, knocking, sparks you should immediately turn the machine off and contact to the 
service center. 

Residual risks 

Despite following the relevant safety instructions and the use of safety devices some residual risks cannot be 
completely eliminated. These include:

• 

Injuries from touching moving parts of the tool.

• 

Risk of pinching fingers when changing tooling.

• 

Damage to health from exposure to vibration arising at work.