DENZEL BLDL-IB-18-02 26121 - Инструкция по эксплуатации - Страница 11

11

CORDLESS DRILL/DRIVER

EN

ATTENTION! 

Always use personal hearing protection.

MAINTENANCE

ATTENTION! 

Before starting maintenance work and setting up the tool disconnect the battery. To ensure 

quality and safe functioning keep your tool and vents clean at all times.

– If you have noticed a decrease in the efficiency of the tool, extraneous noise or smell then you must contact the 
service center for timely diagnosis and repair.
– Tooling maintenance. The use of the worn working tool reduces the effectiveness of the work and may result in 
motor or gearbox failure, so you need to sharpen periodically or replace worn removable tools, as soon as there 
is a need. 
– Electric motor care. You must be especially careful with the electric motor, avoid getting liquids and foreign 
objects inside the case. Keep your ventilation holes clean, blow them regularly with compressed air or clean them 
with a brush. When noticeable sparks appear, contact an authorized service center for diagnostics and possibly 
replacement of carbon brushes.

Possible faults

Fault

Probable cause

Elimination method

The machine does not turn on, 
the charge indicator is not lit.

Low battery.

Charge the battery.

Defective switch.

Call the service center.

The machine does not turn on, 
the charge indicator is lit.

Engine malfunction.

Call the service center.

Increased noise in the gearbox.

Mode switch not fully turned on.

Switch to extreme position.

Worn or broken gearbox.

Call the service center.

Flashes in the vents of the case 
during operation, the smell  
of burning.

Engine malfunction.

Call the service center.

Tooling is not fixed or removed 
from the chuck.

Chuck clogging.

Remove the tooling and clean  
the chuck with compressed air.

Worn or broken chuck.

Call the service center.

The battery is not charging, 
indicator is on.

Battery fault.

Replace battery.

The battery is not charging,  
the lights are off.

Charger malfunction.

Call the service center or replace 
the charger.

RECYCLING

A tool, developed a designated service life, must be recycled according the rules established by environmental 
and other laws of the country, where the tool is operated.