Bosch GO 2 (0.601.9H2.103) - Инструкция по эксплуатации - Страница 25

English | 

25

Changing the Tool

u

Do not use two-sided screwdriver blades that are longer than 25 mm.

Inserting the application tool

Push the application tool into the internal hexagon of the tool holder 

(2)

 until you hear it

engage.

Removing the application tool

Pull the application tool off the tool holder 

(2)

, using pliers if necessary.

Operation

Starting Operation

Setting the rotational direction (see figure B)

u

Do not use the rotational direction switch

(5)

when the power tool is in opera-

tion, as this may damage it.

Clockwise rotation:

 To drive in screws, slide the rotational direction switch 

(5)

 for-

wards.

Anti-clockwise rotation:

 To loosen or unscrew screws, slide the rotational direction

switch 

(5)

 backwards.

Locking the spindle (see figure C)

To lock the spindle in place, slide the rotational direction switch 

(5)

 into the middle posi-

tion.
This allows screws to be driven in even when the battery is discharged and enables the
power tool to be used as a screwdriver.

Preselecting the torque

The torque presetting ring 

(3)

 can be used to preselect the required torque in six stages.

Once the set torque has been reached, the application tool will be stopped.

Stage 1:

Lower torque for driving in screws with a small diameter or for use with soft materials.

Stage 6:

Higher torque for driving in screws with a large diameter or for use with hard materials.

Switching On and Off

There are two ways to start up the power tool.

Bosch Power Tools

1 609 92A 6M4 | (21.05.2021)