Bosch GBM 6 RE 0.601.472.600 - Инструкция по эксплуатации - Страница 18

 English | 

17

Bosch Power Tools

2 609 140 654 | (30.3.09)

Dust/Chip Extraction

f

Dusts from materials such as lead-containing 
coatings, some wood types, minerals and 
metal can be harmful to one’s health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are 
considered as carcinogenic, especially in 
connection with wood-treatment additives 
(chromate, wood preservative). Materials 
containing asbestos may only be worked by 
specialists.
– Provide for good ventilation of the work-

ing place.

– It is recommended to wear a P2 filter-

class respirator.

Observe the relevant regulations in your 
country for the materials to be worked.

Operation

Starting Operation

f

Observe correct mains voltage! The voltage 
of the power source must agree with the 
voltage specified on the nameplate of the 
machine. Power tools marked with 230 V 
can also be operated with 220 V.

Reversing the Rotational Direction 
(see figure C)

The rotational direction switch 

7

 is used to re-

verse the rotational direction of the machine. 
However, this is not possible with the On/Off 
switch 

6

 actuated.

Right Rotation:

 For drilling and driving in 

screws, push the rotational direction switch 

7

left to the stop.

Left Rotation:

 For loosening and unscrewing 

screws and nuts, press the rotational direction 
switch 

7

 through to the right stop.

Switching On and Off

To 

start

 the machine, press the On/Off switch 

6

and keep it pressed.

To lock the 

pressed

 On/Off switch 

6

, press the 

lock-on button 

5

.

To 

switch off

 the machine, release the On/Off 

switch 

6

 or when it is locked with the lock-on 

button 

5

, briefly press the On/Off switch 

6

 and 

then release it.

Adjusting the Speed

The speed of the switched on power tool can be 
variably adjusted, depending on how far the 
On/Off switch 

6

 is pressed.

Light pressure on the On/Off switch 

6

 results in 

a low rotational speed. Further pressure on the 
switch results in an increase in speed.

Working Advice

f

Apply the power tool to the screw/nut only 
when it is switched off. 

Rotating tool inserts 

can slip off.

For drilling in metal, use only perfectly sharp-
ened HSS drill bits (HSS = high-speed steel). The 
appropriate quality is guaranteed by the Bosch 
accessories program.
Twist drills from 2,5 – 10 mm can easily be 
sharpened with the drill bit sharpener (see ac-
cessories).

Belt Clip

With the belt clip 

4

, the machine can be hung 

onto a belt. The user has both hands free and 
the machine is always at hand.

Maintenance and Service

Maintenance and Cleaning

f

Before any work on the machine itself, pull 
the mains plug.

f

For safe and proper working, always keep 
the machine and ventilation slots clean.

If the replacement of the supply cord is neces-
sary, this has to be done by Bosch or an author-
ized Bosch service agent in order to avoid a safe-
ty hazard.

OBJ_BUCH-836-003.book  Page 17  Monday, March 30, 2009  10:50 AM