REXEL Alpha Х - Инструкция по эксплуатации - Страница 5

G

Auto shred and stop

1

  Place the paper or credit card into the centre of the entry 

slot - shredding will start automatically (fig 2).

2

  Paper smaller than A4 in width should be placed in the 

middle of the entry slot to ensure the shredder works 
automatically.

3

  The cutters will stop rotating automatically after finishing 

shredding

4

  Do not shred more than the stated sheet capacity at a time.

5

  Do not attempt to shred more than one credit card at a 

time.

6

  If too many sheets are inserted at a time, the shredder can 

become jammed. If the shredder becomes jammed, switch 
the button to REV position to clear the jam by reversing the 
paper. If the paper has become so entangled in the cutter 
that it can’t be reversed, turn off the power and pull out 
the paper by hand. Restart with fewer sheets and feed the 
nonshredded end of the paper in first.

If the paper shredder will not start, please check the following:

1

 Is the machine plugged in correctly?

2

 Is the switch pushed to the ‘ON/AUTO’ position?

3

 Is the machine jammed with paper?

4

 Has the motor overheated?

In case of jammed paper, please follow the procedure below:

1

  Check if the bin is too full with paper - the bin should be 

emptied regularly to avoid paper becoming jammed in the 
cutters.

2

  Slide the switch to ‘REV’ position to reverse the jammed 

paper.

3

  If the paper is so jammed that it will not come out in 

reverse function, slowly push the switch between ‘REV’ and 
ON/AUTO. Don’t do this too quickly as this can damage the 
shredder.

4

  WARNING – Do not under any circumstances use any metal 

objects (scissors, letter openers etc.) in an attempt to clear 
the entry – this model has mains voltage inside the casing, 
which could cause serious injury.

This machine does not require lubricant. Acco-Rexel accepts no liability for product performance or safety should any lubricant be 
used on any part(s) of this machine.

CAUTION: Don’t let the machine operate 
continuously for more than 3 minutes. When 
the motor has overheated, the thermal safety 
switch will start working automatically. If the 
thermal switch trips, do not use the machine 
for about 30 minutes while the thermal 
sensitive safety switch cools down so the 
shredder can be safely used again.
•  Never insert fingers into the entry slot of the 

shredder.

•  Turn the power off immediately if your hair, 

tie or sleeve becomes entangled in the 
shredder.

•  Empty the shredder bin when it is full 

otherwise the shredder’s performance will be 
adversely affected. Operating the shredder 
with a full shredder bin can result in paper 
jamming in the cutters, which will increase 
the machine’s noise level.

•  Don’t force down shredder paper in the bin 

using your feet.

m