Makita DGA504Z - Инструкция по эксплуатации - Страница 13

13 

• 

Do not start the cutting operation in the workpiece. 
Let the wheel reach full speed and carefully enter 
into the cut moving the tool forward over the 
workpiece surface.    The wheel may bind, walk up 
or kickback if the power tool is started in the 
workpiece. 

• 

During cutting operations, never change the angle 
of the wheel. Placing side pressure on the cut-off 
wheel (as in grinding) will cause the wheel to crack 
and break, causing serious personal injury. 

• 

A diamond wheel shall be operated perpendicular 
to the material being cut. 

Operation with wire cup brush   
(optional accessory) 

CAUTION: 

• 

Check operation of brush by running tool with no 
load, insuring that no one is in front of or in line 
with brush. 

• 

Do not use brush that is damaged, or which is out 
of balance. Use of damaged brush could increase 
potential for injury from contact with broken brush 
wires. 

Fig.21 

Remove the battery cartridge from the tool and place it 
upside down allowing easy access to spindle. Remove 
any accessories on spindle. Thread wire cup brush onto 
spindle and tighten with supplied wrench. When using 
brush, avoid applying too much pressure which causes 
over bending of wires, leading to premature breakage. 

Operation with wire wheel brush   
(optional accessory) 

CAUTION: 

• 

Check operation of wire wheel brush by running 
tool with no load, insuring that no one is in front of 
or in line with the wire wheel brush. 

• 

Do not use wire wheel brush that is damaged, or 
which is out of balance. Use of damaged wire 
wheel brush could increase potential for injury 
from contact with broken wires. 

• 

ALWAYS use guard with wire wheel brushes, 
assuring diameter of wheel fits inside guard. 
Wheel can shatter during use and guard helps to 
reduce chances of personal injury. 

Fig.22 

Remove the battery cartridge from the tool and place it 
upside down allowing easy access to spindle. Remove 
any accessories on spindle. Thread wire wheel brush 
onto spindle and tighten with the wrenches. 
When using wire wheel brush, avoid applying too much 
pressure which causes over bending of wires, leading to 
premature breakage. 

MAINTENANCE 

CAUTION: 

• 

Always be sure that the tool is switched off and the 
battery cartridge is removed before attempting to 
perform inspection or maintenance. 

• 

Never use gasoline, benzine, thinner, alcohol or the 
like. Discoloration, deformation or cracks may result. 

Fig.23 

The tool and its air vents have to be kept clean. 
Regularly clean the tool's air vents or whenever the 
vents start to become obstructed. 

Fig.24 

Remove the dust cover from inhalation vent and clean it 
for smooth air circulation. 

NOTE: 

• 

Clean out the dust cover when it is clogged with 
dust or foreign matters. Continuing operation with 
a clogged dust cover may damage the tool. 

To maintain product SAFETY and RELIABILITY, repairs, 
any other maintenance or adjustment should be 
performed by Makita Authorized Service Centers, 
always using Makita replacement parts. 

OPTIONAL ACCESSORIES 

CAUTION: 

• 

These accessories or attachments are 
recommended for use with your Makita tool 
specified in this manual. The use of any other 
accessories or attachments might present a risk of 
injury to persons. Only use accessory or 
attachment for its stated purpose. 

If you need any assistance for more details regarding 
these accessories, ask your local Makita Service Center. 

• 

Makita genuine battery and charger