Bosch GGS 28 CE - Инструкция по эксплуатации - Страница 19

 English | 

19

Bosch Power Tools

3 609 929 C06 | (16.12.10)

f

Use extra caution when making a “pocket 
cut” into existing walls or other blind areas. 

The protruding wheel may cut gas or water 
pipes, electrical wiring or objects that can 
cause kickback.

Safety warnings specific for polishing 
operations (GGS 8 CE)

f

Do not allow any loose portion of the polish-
ing bonnet or its attachment strings to spin 
freely. Tuck away or trim any loose attach-
ment strings. 

Loose and spinning attach-

ment strings can entangle your fingers or 
snag on the workpiece.

Safety warnings specific for wire brushing 
operations (GGS 8 CE)

f

Be aware that wire bristles are thrown by 
the brush even during ordinary operation. 
Do not overstress the wires by applying ex-
cessive load to the brush. 

The wire bristles 

can easily penetrate light clothing and/or 
skin.

f

Allow brushes to run at operating speed for 
at least one minute before using them. Dur-
ing this time no one is to stand in front or in 
line with the brush. 

Loose bristles or wires 

will be discharged during the run-in time.

f

Direct the discharge of the spinning wire 
brush away from you. 

Small particles and ti-

ny wire fragments may be discharged at high 
velocity during the use of these brushes and 
may become imbedded in your skin.

Additional safety warnings

Wear safety goggles.

f

Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call 
the local utility company for assistance. 

Contact with electric lines can lead to fire 
and electric shock. Damaging a gas line can 
lead to explosion. Penetrating a water line 
causes property damage or may cause an 
electric shock.

f

Release the On/Off switch and set it to the 
off position when the power supply is inter-
rupted, e. g., in case of a power failure or 
when the mains plug is pulled. 

This prevents 

uncontrolled restarting.

f

Secure the workpiece. 

A workpiece clamped 

with clamping devices or in a vice is held 
more secure than by hand.

Products sold in GB only

: Your product is fitted 

with an BS 1363/A approved electric plug with 
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, 
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the 
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a 
possible shock hazard and should never be in-
serted into a mains socket elsewhere.

Products sold in AUS and NZ only

: Use a resid-

ual current device (RCD) with a rated residual 
current of 30 mA or less.

Product Description and 
Specifications

Read all safety warnings and all in-
structions. 

Failure to follow the 

warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.

While reading the operating instructions, unfold 
the graphics page for the machine and leave it 
open.

Intended Use

The machine is designed for grinding and de-
burring metal using corundum grinding tools, as 
well as for working with sanding wheels.
GGS 8 CE: The machine is additionally intended 
for brushing and polishing metal.

OBJ_BUCH-1269-003.book  Page 19  Thursday, December 16, 2010  4:05 PM