Einhell PXC GE-GS 18 - Инструкция по эксплуатации - Страница 18

GB

- 18 -

then begin to blink.

3.  Push the battery pack onto the battery char-

ger.

In section 10 (Charger indicator) you will 

fi

 nd a 

table with an explanation of the LED indicator on 

the charger.

If the battery pack fails to charge, check for the 

following:

• 

voltage at the power socket

• 

whether there is good contact at the charging 

contacts of the charging unit.

If the battery pack still fails to charge, send

• 

the charger and charging adapter

• 

and the battery pack

• 

to our customer service center.

5.4 Battery capacity indicator (Fig. 4/Item D)

Press the button for the battery capacity indicator 

(E). The battery capacity indicator (D) will indicate 

the charge status of the battery by means of 3 

LEDs.

All 3 LEDs are lit:

The battery is fully charged.

2 or 1 LED(s) are lit:

The battery has an adequate remaining charge.

1 LED blinks:

The battery is empty, recharge the battery.

All LEDs blink:

The battery pack has undergone exhaustive di-

scharge and is defective. Do not use or charge a 

defective battery pack.

6. Operation

6.1 On/O

ff

  switch (Fig. 1/Item 1)

Switching on:

Press the locking button (2) and the On/O

ff

  switch 

(1).

In

fi

 nitely variable stroke speed control is possible 

with the On/O

ff

  switch (1). The further you push 

the switch, the higher the stroke speed.

Switching o

ff

 :

Release the locking button (2) and the ON/OFF 

switch (1) at the same time.

6.2 Using as a universal jig saw (Fig. 6)

Place the universal saw, as shown in Fig. 6, on 

the material you want to cut. Switch on the univer-

sal saw and push the universal saw against the 

material you want to cut. The cutting speed must 

be adjusted to the material.

6.3 Using as a tree pruning saw (Fig. 7)

Place the tree pruning saw, as shown in Fig. 7, 

on the branch you want to cut. Switch on the 

tree pruning saw and push the tree pruning saw 

against the branch you want to cut. The branch 

jaw clamp will help you to guide the equipment in 

a straight line. The cutting speed must be adjus-

ted to the material.

7.  Cleaning, maintenance and 

ordering of spare parts

Hazard!

Always pull out the battery pack before starting 

any cleaning work.

7.1 Cleaning

• 

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

• 

 We recommend that you clean the device  

immediately each time you have finished 

using it.

• 

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

7.2 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

7.3 Ordering replacement parts:

Please quote the following data when ordering 

replacement parts:

• 

 Type of machine

Anl_GE_GS_18_Li_SPK7.indb   18

Anl_GE_GS_18_Li_SPK7.indb   18

27.09.2016   11:39:14

27.09.2016   11:39:14