Dreame L10S Ultra - Инструкция по эксплуатации - Страница 14

12

EN

- MAX -

5. Place the Robot

Press and hold the 

 button on the robot for 3 seconds to turn it on. Place 

the robot onto the base station with the mop assembly facing toward 

the washboard. Then you will hear a voice notification when the robot 

successfully connects to the base station and starts charging. After the robot 

is fully charged, the status indicators on the robot and the base station will 

remain lit for 10 minutes and will then dim.

6. Install the Cleaner Bottle

Remove the cap of the cleaner bottle, and tear off the seals on the upper and 

bottom of the bottle. Open the upper cover of the base station and take out 

the clean water tank and the used water tank. Install the cleaner bottle along 

the slot into place. The cleaner will be added automatically while working.

7. Add Water to the Clean Water Tank

Fill the clean water tank with clean water up to the maximum water level 

mark, and then install the clean water tank and the used water tank in place.

Before Use

Note: 

It is recommended to fully charge the robot before its first use. When the 

robot cannot be turned on after the battery is depleted, manually connect the 

robot with the station to charge it.

MAX Water Line

Note: 

Do not add hot water to the water tank, as this may cause the tank to become 

deformed.

Note: 

·

Remove the soft rubber plug in the cleaner adding inlet before first use.

·

Do not add any liquid other than the officially-approved cleaner to help prevent 
base station malfunction.

③

②

①