Worx WX678.9 - Инструкция по эксплуатации - Страница 8

Oscillating Tool                     EN

8

Avoid danger of injury from the 

sharp edges of the accessories. 

Accessories can become very hot 

while working, presenting danger 

of burns!

Make sure the battery is 

removed prior to changing 

accessories.

Wear protective gloves

High oscillation frequency.

Low oscillation frequency.

 -  -  -  

 -  -  -  

=

LED light is a battery capacity 

indicator and will flash when power 

gets low .

Waste electrical products should 

not be disposed of with household 

waste. Please recycle where fa-

cilities exist. Check with your Local 

Authority or retailer for recycling 

advice.

OPERATING INSTRUCTIONS

NOTE: 

Before using the tool, read the 

instruction book carefully.

INTENDED USE:

The power tool is intended for sawing and 

remodelling wooden materials, plastic, plaster, 

non-ferrous metals and fasteners (e.g. nails and 

clamps) as well as for working on soft wall tiles and 

for dry grinding of small surfaces. It is especially 

suitable for working close to edges and for flush 

cutting. 

ASSEMBLY AND OPERATION

Action 

Figure

Mounting accessories

See Fig. A-C

Mounting the sanding sheet

See Fig. D

Mounting the suction device 

(not supplied)

See Fig. E1-E5

Operating the on/off switch

See Fig. F

Using the variable speed dial

See Fig. G

Remove or install battery pack

See Fig. H

LED Light

See Fig. I

The Variable Speed Dial can be used to set the 

optimum oscillating frequency according to the 

accessories used and the respective application.

Oscillation 

frequency

Application

High oscillation 

frequency:

Sanding, Sawing, Rasping 

and Polishing Stone and 

Metal.

Low oscillation 

frequency:

Scraping, Polishing 

Varnishes.

DISPOSAL OF AN 

EXHAUSTED BATTERY PACK 

To preserve natural resources, please recycle 

or dispose of the battery pack properly. This 

battery pack contains Lithium batteries. Consult 

your local waste authority for information regarding 

available recycling and/or disposal options. Discharge 

your battery pack by operating your drill, then remove 

the battery pack from the drill housing and cover the 

battery pack connections with heavy-duty adhesive 

tape to prevent short circuit and energy discharge. 

Do not attempt to open or remove any of the 

components.

WORKING HINTS FOR YOUR 

TOOL

If your power tool becomes too hot, especially when 

used at low speed, set the speed to maximum and run 

it with no load for 2-3 minutes to cool the motor. Avoid 

prolonged usage at very low speeds.  Always keep the 

blade sharp.

Always ensure the workpiece is firmly held or clamped 

to prevent movement.

Any movement of the material may affect the quality 

of the cutting or sanding finish.

Start your tool before working and turn it off only after 

you stop working.