Brayer BR4221 - Инструкция по эксплуатации - Страница 9

9

EN

• 

Before cleaning always make sure that the filters (19, 

24) are installed properly.

•  Take the power plug and unwind the power cord to the 

required length, connect the power plug to the mains 

socket.

•  The yellow mark on the power cord indicates the 

maximum cord length. Do not pull out the power cord 

further than the red mark.

• 

Press the on/off button (15) to switch the vacuum 

cleaner on.

•   While cleaning you can control the suction power 

using the manual suction power control (6) on the 

flexible hose handle (5) and by turning the suction 

power control (16).

• 

After you finish cleaning, switch the vacuum cleaner off 

by pressing the on/off button (15) and unplug it.

•  To wind the power cord, press the button (18); keep a 

hold of the winding cord with your hand. 

•  If you have to make a break during the cleaning, 

switch the vacuum cleaner off by pressing the button 

(15) and install the brush (1) to the brush storage (19).

ATTENTION!
Before changing the attachments or cleaning the 

dust bin (20), switch the vacuum cleaner off by 

pressing the on/off button (15) and unplug it.

CLEANING AND  MAINTENANCE
Cleaning the dustbag (15)

•  If during cleaning the full dustbag indicator (14) turns 

red, clean the dustbag (20) or replace the disposable 

paper dustbag (27)

Note:

 the paper dustbag (27) is disposable, when the 

dustbag (27) is full, dispose of it.
•  Before cleaning the dustbag (20), switch the vacuum 

cleaner off by pressing the on/off button (15) and unplug it.

•  Open the dustbag compartment lid (13) by pressing the lid 

lock (12).

•  Remove the dustbag holder (21) with the dustbag (20) 

(pic. 3).

•  Take the dustbag (20) out from the holder (21).

•  Place the dustbag (20) above the garbage bin, remove the 

plastic clamp and clean the dustbag (20) of garbage and 

dust. You can wash the dustbag (20) with warm water and 

soft detergent, rinse and dry thoroughly. After that install 

the plastic clamp on the dustbag (20).

•  Install the dustbag (20) into the holder (21).

•  Put the dustbag holder (21) with the dustbag (20) installed 

into the dustbag compartment body.

•  Close the dustbag compartment lid (13) and slightly press 

on the lid (13) until the lock (12) clicks.

Notes:

– do not try to close the lid (13) without the dustbag holder 

(21) installed, otherwise you can damage the lock or the lid 

(13);
– before closing the lid (13), always make sure that the 

dustbag holder (21) and the dustbag (20 or disposable paper 

dustbag 27) are installed properly.