VITEK VT-1886 B - Инструкция по эксплуатации - Страница 5

Пылесос VITEK VT-1886 B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 32
Загружаем инструкцию
background image

5

ENGLISH          

– 

there is no water in the aqua filter tank; 

– 

not all filters are installed.

 •

Do  not  immerse  the  unit  body  into  water  or 
other liquids.

 •

Clean the vacuum cleaner regularly.

 •

Close supervision is necessary when children 
under 8 years of age or disabled persons are 
near the operating unit.

 •

This unit is not intended for usage by children 
under 8 years of age. 

 •

This  unit  is  not  intended  for  usage  by  people 
(including children over 8) with physical, neu-
ral  and  mental  disorders  or  with  insufficient 
experience or knowledge. Such persons may 
use this unit only if they are under supervision 
of a person who is responsible for their safety 
and  if  they  are  given  all  the  necessary  and 
understandable  instructions  concerning  the 
safe  usage  of  the  unit  and  information  about 
danger  that  can  be  caused  by  its  improper 
usage.

 •

Do  not  leave  children  unattended  to  prevent 
using the unit as a toy.

 •

For  children  safety  reasons,  do  not  leave 
polyethylene  bags  used  as  packaging  unat-
tended. 

Attention!

  Do  not  allow  children  to  play  with 

polyethylene bags or packaging film. 

Danger of 

suffocation!

 •

To avoid damages, transport the unit in origi-
nal package only.

 •

Make  sure  regularly  that  the  power  cord  and 
the  plug  are  not  damaged.  If  the  power  cord 
or plug is damaged or vacuum cleaner oper-
ates  improperly,  contact  an  authorized  ser-
vice center.

THE  UNIT  IS  INTENDED  FOR  HOUSEHOLD 
USAGE ONLY

Safety measures

 •

Do not use the vacuum cleaner near hot sur-
faces,  ashtrays  and  in  places  where  inflam-
mable liquids are stored.

 •

Take sharp objects away from the floor before 
cleaning to prevent unit damage.

 •

If  the  suction  power  of  the  vacuum  cleaner 
decreases  rapidly  while  cleaning,  switch  it 
off  immediately  and  check  the  telescopic 
pipe  and  the  flexible  hose  for  obstruction. 
Switch  the  vacuum  cleaner  off,  then  unplug 
it,  remove  the  obstruction  and  only  after  that 
continue cleaning.

ASSEMBLING THE VACUUM CLEANER

After  unit  transportation  or  storage  under 
cold  (winter)  conditions,  it  is  necessary  to 
keep  it  for  at  least  two  hours  at  room  tem-
perature before switching on. 
Unpack  the  vacuum  cleaner  completely  and 
check it for damages. Do not use the unit in case 
of damages.
Note:

– 

Before  switching  the  unit  on,  make  sure 
that  your  home  mains  voltage  corresponds 
to  the  operating  voltage  of  the  vacuum 
cleaner.

– 

Always  switch  the  vacuum  cleaner  off  and 
unplug  it  while  replacing  the  brush  attach-
ments and before cleaning the dust bin (8).

Filling the aqua filter tank (11) with water.

 •

Remove  the  dust  bin  (8)  by  pressing  the 
release button (6) and pulling it by the handle 
(7) (pic. 1).

 •

Open  the  locks  (9),  take  the  dust  bin  by  the 
carrying  handle  (7)  and  remove  the  dust  bin 
lid with the filter block (pic. 2).

 •

Fill  the  tank  (11)  with  water  up  to  the  MAX 
mark.

Note: 

– 

The  required  water  amount  is  approximately 
500 ml.

 •

Install the dust bin lid with the filter block into 
the  tank  (11).  Make  sure  that  it  is  installed 
properly.

 •

Close the locks (9).

 •

Install the dust bin (8) to its place until the lock 
(6) clicks.

AT TENTION!

 

Do not exceed the “MAX” mark.

 

Make  sure  that  the  dust  bin  lid  and  dust 
bin  (8)  are  installed  properly  on  the  vac-
uum cleaner body. To avoid damage of the 
lid  and  dust  bin  (8)  when  installing  them, 
do not apply excessive effort.

Attaching flexible hose, telescopic pipe  
and attachments 

 •

Insert the flexible hose ending (12) into the air 
inlet  (10)  until  the  release  buttons  (13)  click 
(pic. 3). 

 •

To  remove  the  flexible  hose  (14),  press  the 
release  buttons  (13)  of  the  ending  (12)  and 
detach the hose (14). 

 •

Insert  the  flexible  hose  handle  (15)  into  the 
telescopic extension pipe (16) (pic. 4). 

VT-1886.indd   5

23.07.2014   11:42:57

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к VITEK VT-1886 B?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"