VITEK VT-1847 R/B - Инструкция по эксплуатации - Страница 6

6

•  Do not allow any objects to block the in-

lets and outlets of the vacuum cleaner. 
If any of the outlets is blocked, do not 
switch on the appliance. Watch there is 
no dust, hairs, fluff, and other trash col-
lected on the filters as it would block the 
normal airflow. 

• Watch the hairs, the ends of the cloths 

hanging down, fingers or other parts of 
the body are not near by any vacuum 
cleaner inlets

.

• Always switch the appliance off by ON/

OFF button before unplugging it from the 
wall outlet

.

•  Take special care while cleaning the stair-

cases

.

• Do not use the appliance for collecting 

the inflammable liquids (gasoline, dis-
solvent, etc.). Do not use the appliance 
at the places where such a liquids are 
stored

.

•  Do not use the appliance to pick up water 

or other liquids, burning or gleaming cig-
arettes, matches, smoldering ash, thin 
powders, like plaster, concrete, flour or 
ash dust, sharp and cutting things. Doing 
so would course serious electric motor 
damages. 

  Remember, warranty does not extend to 

such damages

.

• Do not use the vacuum cleaner without 

dust collecting container or if the filters 
are not installed in the container.

• Hold the power cord by your hand while 

winding it. Do not allow the plug to strike 
on the floor

.

Keep these instructions in touch, use it (if 
required) for reference.

Precautions

If suction power is suddenly down while 
cleaning, switch the vacuum cleaner off 
immediately and check out if its telescopic 
tube or flexible hose is blocked. Switch off 
the vacuum cleaner, then unplug the cord 

from the wall outlet, remove the blocking 
substance, and continue cleaning.

-  

Do not operate the vacuum cleaner too 
close to the heated surfaces, cigarette 
butts, and in the areas where the flam-
mable or combustible liquids are kept

.

-  

Insert the plug into the wall outlet by the 
dry hands only

.

-  

Before cleaning remove the sharp ob-
jects from the floor in order to prevent the 
filters damages

.

-

  To disconnect the power cord from the 

wall outlet hold the plug, do not pull it out 
by the power cable

.

Assembling vacuum cleaner

Unpack the vacuum cleaner completely 
and ensure there are no any damages. Any 
factory defects or transportation damages 
are the subjects of VITEK warranties.
Verify the vacuum cleaner voltage meets 
the mains voltage in your supply line before 
switching the appliance on. 
Always switch off and unplug the vacuum 
cleaner to change the nozzles or for main-
tenance. 

Connecting and removing flexible hose 
(Pic.1)

Insert the flexible hose tip (4) into the air in-
let located on the front panel of the vacuum 
cleaner housing. Insert the hose up to the 
click indicating the connection is proper. To 
remove the flexible hose press fixing button 
(5), and detach it.

Connection of telescopic tubes and 
nozzles

-  Connect the telescopic extension tube 

(2) to the flexible hose handle (3) (Pic. 
2). Press fixing button and pull out the 
lower part of the telescopic tube up to 
the length you need (Pic. 3).

-   Choose the nozzle you need: turbo brush 

(1), floor/carpet brush (22), small brush 
(23), nozzle for cleaning the furniture 

 ENGLISH

1847.indd   6

1847.indd   6

06.03.2009   12:15:51

06.03.2009   12:15:51