VITEK VT-1845 R/B - Инструкция по эксплуатации - Страница 6

6

10.  Do not allow any objects to block the out-

lets of the vacuum cleaner.

If any of the outlets is blocked, do not switch 
on the appliance. 

11.  Watch the hairs, the ends of the cloths 

hanging down, fingers or other parts of the 
body are not near by any vacuum cleaner 
inlets.

12.  Always switch the appliance off by ON/OFF 

button before unplugging it from the wall 
outlet.

13.  Take special care while cleaning the stair-

cases.

14.  Do not use the appliance for collecting the 

inflammable liquids (gasoline, dissolvent, 
etc.). Do not use the appliance at the plac-
es where such a liquids are stored. 

15.  Do not use the appliance to pick up wa-

ter or other liquids, burning or gleaming 
cigarettes, matches, smoldering ash, thin 
powders, like plaster, concrete, flour or ash 
dust, sharp and cutting things. This may 
course serious electric motor damages. 
Remember, warranty does not extend to 
such damages. 

16. Do not use the vacuum cleaner if dust col-

lecting container and filters are not installed 
properly.

17. Hold the power cord by your hand while 

winding it. Do not allow the plug to strike on 
the floor.

KEEP THIS MANUAL IN TOUCH, USE IT (IF 

REQUIRED) FOR REFERENCE.

PRECAUTIONS

If suction power is suddenly down while clean-
ing, switch the vacuum cleaner off immediately 
and check out if its telescopic tube or flexible 
hose is blocked. Switch off the vacuum clean-
er, then unplug the cord from the wall outlet, 
remove the blocking substance, and continue 
cleaning.
•  Do not operate the vacuum cleaner too close 

to the heated surfaces, cigarette butts, and 
in the areas where the flammable or combus-
tible liquids are kept.

•  Before to insert the plug into the wall outlet, 

you should make sure that your hand is dry.

•  Before you start using the vacuum cleaner, 

please remove the large or sharp objects 

from the floor in order to prevent the filters 
damages.

•  To disconnect the power cord from the wall 

outlet hold the plug, not the electrical cable.

Assembling vacuum cleaner

Unpack the vacuum cleaner completely and 
ensure there are no any damages. Any factory 
defects or transportation damages are the sub-
jects of VITEK warranties.
Verify the vacuum cleaner voltage meets the 
mains voltage in your supply line before switch-
ing the appliance on. 
Always switch off and unplug the vacuum clean-
er to change the nozzles or for maintenance. 

1. Connecting and removing flexible hose 
(Pic.1)

Insert the flexible hose tip (4) into the air inlet 
(6). Insert the hose up to the click indicating 
the connection is proper. To remove the flexible 
hose press fixing button (5), and detach it.

2. Connection of telescopic tubes and 
brushes

-   Connect the telescopic extension tube (2) to 

the flexible hose handle (3) (Pic. 2). Press fix-
ing button and pull out the lower part of the 
telescopic tube up to the length you need 
(Pic. 3).

-   Choose the nozzle you need: turbo brush (1), 

crevice nozzle (27), nozzle for cleaning the 
furniture coverings (29), small brush (28) or 
floor/carpet brush (30), and connect it to the 
telescopic extension tube (Pic. 4).

Using brushes and nozzles
Turbo brush for floor/carpets (1)

Use turbo brush (1) to clean the floor, carpets 
and covers with long and short nap, it is ideal 
for cleaning the wool out from the carpets. Cyl-
inder brush with coarse nap is rotated by the 
air flow, its nap brushes the wool and removes 
small dirties out of the carpet nap very effec-
tively.

Notice: to avoid a carpet damage caused by 
the brush rotation, do not use the turbo brush 
for cleaning the carpets with very long nap, 
more then 15 cm length. Do not touch the elec-
trical wires by the rotating the brush. 

 ENGLISH

1845.indd   6

1845.indd   6

14.04.2010   9:29:44

14.04.2010   9:29:44