VITEK VT-1843 B/R/SR - Инструкция по эксплуатации - Страница 5

emitting cigarettes, matches, smoldering 
ashes or fine dust such as from plaster, 
cement, flour or cinder. It can lead to se-
rious damages of the electro motor, and 
take into account that such cases are not 
under warranty.

Do not use the vacuum cleaner: 

• 

- without the container for dust and 

rubbish;

-  without the cone filter;
-  without the input and output НЕРА filters 

and the foam filter.
Check the power cord and the power plug 

• 

for damages regularly. If there are some 
damages in the power cord, the power 
plug, or if the unit malfunctions, apply to 
the authorized service center.

The unit is intended for household usage 

• 

only; commercial usage of the vacuum 
cleaner is prohibited.

STORE THE INSTRUCTIONS IN A CONVENIENT 
PLACE

Safety measures

-    If during vacuum-cleaning the suction force 

sharply decreased, switch off the vacuum 
cleaner immediately and check the exten-
sion pipe and flexible hose with respect to 
blockage. Switch off the vacuum cleaner 
and unplug it, remove the blockage and 
then continue the cleaning.

-   Do not use the vacuum cleaner near heat-

ed sources, near an ash tray and in places 
where flammable liquids are stored.

-   Insert the plug in the socket only with dry 

hands.

-   While extracting the plug from the socket 

always take the plug, do not pull the power 
cord.

Assembly

-   Unpack the unit.
-   Before turning on the vacuum cleaner, 

make sure that the voltage of the mains 
corresponds to the voltage of the vacuum 
cleaner.

-   Always turn off the vacuum cleaner and 

unplug it from the outlet before changing 
the brushes, and before cleaning the con-
tainer.

-   Make sure that the input filters (14 and 15), 

the output filter (16), the cone filter (20) 
and the container for dust and rubbish it-
self (7), are properly installed.

-   Insert the end of the flexible hose (5) in the 

air inlet (6), by matching the ledges on the 
tip with the grooves on the air inlet and turn 
the tip (5) clockwise until bumping. To re-
move the tip of the flexible hose (5) turn it 
anticlockwise and then pull to you.

-   Attach the telescoping extension pipe (2) 

to the flexible hose handle (3). Extend the 
lower part of the telescoping pipe to the 
desired length by pressing the clamp but-
ton for convenient operation.

-   Select the desired attachment: carpet/

floor brush (1), turbo brush (22), crevice 
attachment (23) or small brush (21), and 
put it on the telescopic pipe (2), the at-
tachments (21) and (23) can be put on the 
handle of the flexible hose (3).

Floor/carpets brush (1) 

Set the switch on the brush to the desired po-
sition (depending on the type of the surface 
you wish to clean).

Small brush (21)

The brush is intended to collect dust from the 
surface of the furniture, presence of pile pre-
vents polished surface of the furniture from 
damages.

Turbo-brush for floor/carpets (22)

The turbo brush (22) can be used to clean 
floors, rugs and carpets with long or short 
pile, and is ideal for picking up animal fur. The 
cylindrical brush with hard bristles rotates un-
der the action of the air current and its bristles 
effectively remove animal fur and loose car-
pet and rug fibers.

Note: 

Never use the turbo brush to clean rugs 

with fringe and pile of 15 mm or more, be-
cause the rotating brush can cause damage 

5

              ENGLISH         

VT_1843_instruk.indd   5

VT_1843_instruk.indd   5

01.07.2011   10:43:13

01.07.2011   10:43:13