VITEK VT-1833 PR/R/G - Инструкция по эксплуатации - Страница 6

6

 ENGLISH

Small brush (15)

The brush is intended to collect dust from 
the surface of the furniture, presence of pile 
prevents polished surface of the furniture 
from damages.

Crevice attachment (16)

The attachment is intended for cleaning of 
radiators, crevices, corners and between 
sofa pillows. 

Attachment for furniture upholstery 
cleaning

(17)

Attachment is intended to clean fabric sur-
face of upholstered furniture. 

Turbo-brush (18)

The turbo brush (18) can be used to clean 
floors, rugs and carpets with long or short 
pile, and is ideal for picking up animal fur. 
The cylindrical brush with hard bristles ro-
tates under the action of the air current and 
its bristles effectively remove animal fur and 
loose carpet and rug fibers.

Note: 

Never use the turbo brush to clean 

rugs with fringe and pile of 15 mm or more, 
because the rotating brush can cause 
damage to such rugs. Do not run the turbo 
brush over power cords and turn off the 
vacuum cleaner immediately after you are 
done using it.

USAGE INSTRUCTIONS

Attention!
The vacuum cleaner with a water filter 
is intended only for dry cleaning; do not 
use the unit to pick up water or any oth-
er liquids.  

Before using the vacuum cleaner, pull the 
power cord out to the desired length and in-
sert the plug into an outlet. The yellow mark 
on the power cord warns you when to stop 
pulling. Never pull the power cord past the 
red mark.

Attention!
Always turn on the vacuum cleaner only 

with the installed dust-collecting bin 
filled with water and with the installed fil-
ters (20, 21, 24). Always check whether 
the filters are installed properly or not.

•  To turn on the vacuum cleaner press the 

On/Off button (3).

•  During operation you can adjust suction 

power using the suction control (2).

•  After the cleaning is over, press the On/

Off button (3) and take the plug out of the 
socket.

•  Press the power cord-winding button (1), 

and hold the winding cord with your hand 
to prevent damage.

SERVICE

•  When water in the bin (19) becomes dirty 

(suction power can be reduced), you 
should pour out it, to proceed with clean-
ing, fill the bin with clear water, refer to 
the “Cleaning of the dust-collecting bin” 
section.

 Note: 

it is recommended that you empty 

the dust collection bin and wash the bin 
after each use.

•  Before removal of the dust-collecting bin, 

it is necessary to turn off the unit with the 
switch (3), and then unplug the unit.

Cleaning of the dust-collecting bin

•  Holding the handle (5) press the locking 

button (4) and take the bin out of the vac-
uum cleaner (pic. 1).

•  Open the latches (25) and remove the lid 

of the bin (19).

•  Pour out dirty water from the lower part of 

the bin (26) and rinse it. 

•  Fill the lower part of the bin (26) with wa-

ter till the MAX mark. 

  Note: Necessary quantity of water - 

600 ml.

•  Put the lid (19) on the lower part of the bin 

(26) and lock the latches (25).

•  Put the dust-collecting bin on its place; 

check that the bin is locked in the case of 
the vacuum cleaner. 

1833.indd   6

1833.indd   6

20.04.2009   9:32:13

20.04.2009   9:32:13