VITEK VT-1833 PR/R/G - Инструкция по эксплуатации - Страница 5

5

              ENGLISH         

up flammable liquids such as petrol, sol-
vents, and never use it where such liquids 
are stored.

•  Never use the vacuum cleaner to pick up 

water or other liquids, burning or smoke-
emitting cigarettes, matches, smoldering 
ashes or fine dust such as from plaster, 
cement, flour or cinder.

•  Do not use the vacuum cleaner: 
-   without dust-collecting bin;
-  if there is no water in the dust-collecting 

bin;

-   if the filters (20, 21, 24) are not installed in 

the dust-collecting bin;

-   if the output filter (13) is not installed 
•  The unit is intended for household usage 

only; commercial usage of the vacuum 
cleaner is prohibited.

STORE THE INSTRUCTIONS IN A 
CONVENIENT PLACE

SAFETY PRECAUTIONS

•   Do not use the vacuum cleaner in the 

immediate vicinity of very hot surfaces, 
next to ash trays, or where flammable 
liquids are stored.

• 

 Before beginning to clean, remove 

sharp objects from the floor to avoid 
damage of the filters.

• 

  If suction power decreases abruptly 

while cleaning, immediately turn off the 
vacuum cleaner and check the tele-
scoping tube or flexible hose for foreign 
objects. Turn off the vacuum cleaner, 
and then unplug it from the power out-
let. Clear the obstruction and only then 
proceed with cleaning.

ASSEMBLING THE VACUUM CLEANER

Completely unpack the vacuum cleaner 
and check it for damages. 
Before turning on the vacuum cleaner, 
make sure that the voltage of the mains 
corresponds to the voltage of the vacuum 
cleaner. 
Always turn off the vacuum cleaner and un-

plug it from the outlet before changing the 
brushes/attachments, and before perform-
ing maintenance on it.

Filling the dust-collecting bin with wa-
ter 

•  Holding the handle (5) press the locking 

button (4) and take the bin out of the vac-
uum cleaner (pic. 1).

•  Open the latches (25) and remove the lid 

of the bin (19).

•  Fill the lower part of the bin (26) with wa-

ter till the MAX mark. 

  Note: Necessary quantity of water - 

600 ml.

•  Put the lid (19) on the lower part of the bin 

(26) and lock the latches (25).

•  Put the dust-collecting bin on its place; 

check that the bin is locked in the case of 
the vacuum cleaner. 

Attaching and removing the flexible 
hose (pic. 2)

•  Insert the end of the flexible hose (8) in 

the air inlet (6). Insert the hose until it 
snaps, confirming a proper connection. 

•  To remove the flexible hose press the 

locks (7) and disconnect the hose.

Attaching the extension tubes and at-
tachments (pic. 3, 4)

•  

Attach the telescoping extension tube 
(11) to the flexible hose handle (10). 

• Extend the lower part of the telescoping 

tube to the desired length by pressing the 
locking button.

•  Select the desired attachment: carpet/

floor brush (12), small brush (15), crevice 
attachment (16), attachment for furniture 
upholstery cleaning (17) or turbo-brush 
(18) and connect it to the telescoping ex-
tension pipe (11).

Carpet/floor brush (12) (pic. 5, 6)

Set the switch on the brush to the desired 
position (depending on the type of the sur-
face you wish to clean).

1833.indd   5

1833.indd   5

20.04.2009   9:32:13

20.04.2009   9:32:13