LG A9N-CORE - Инструкция по эксплуатации - Страница 38

38

EN

Symptoms

Possible Causes & Solution

Hot air is 

expelled from 

the appliance.

Appliance is operating.

•

The hot air originates from cooling of the motor and is not a sign of malfunction.

The appliance 

makes too much 

noise.

Vacuum cleaner operates in Turbo mode.

•

The motor may be louder at the higher suction power settings. This is normal.

The appliance 

turns off 

unexpectedly 

or by itself 

after the motor 

speed fluctuates 

repeatedly.

Battery is not fully charged.

•

The battery must be fully charged before cleaning. If the problem persists 

when the battery is fully charged and the pipes and attachments are clear from 

obstructions, contact an LG customer information center for service.

Foreign object is in the product body, extension pipe, inlet port or nozzle.

•

Remove any foreign objects from the product body, extension pipe, inlet port or 

nozzle.

Filters are clogged.

•

Clean the pre-filter and the exhaust filter.

The rotating 

brush does not 

rotate.

Brush is improperly installed.

•

Remove the brush, clean it if necessary and attach it again.

Foreign object is on rotating brush.

•

Remove any foreign objects from the rotating brush.

The mop pad 

attachment plate 

does not rotate.

Mop pads are improperly installed.

•

Remove the mop pads, clean it if necessary and attach it again.

Mop nozzle is strongly pressed.

•

The mop attachment plate stops automatically to protect the product. This is not a 

failure. Attach the mop pads securely to the mop attachment plate and press the 

power button to resume use.

Foreign object is between mop attachment plate and mop pads.

•

Remove foreign objects from the mop nozzle attachment plate and press the 

power button to resume use.

There is no water 

coming out of 

the mop nozzle.

Water tank is empty.

•

Fill the water tank. Remove the battery or detach the nozzle before filling the 

water tank.

Water tank is improperly attached to mop nozzle.

•

Properly attach the water tank to the mop nozzle. Remove the battery or detach 

the nozzle before properly securing the water tank to the nozzle.

Water supply adjustment button is set to STOP.

•

Press the High or Low water adjustment button all the way down. The water will 

not come out if the button is set to STOP.

There is 

moisture in the 

water tank.

Water tank is not allowed to dry completely after use.

•

Empty the water tank, set it out of direct sunlight, and allow it to dry completely 

after use.

Using the mop 

nozzle makes the 

floor dirtier.

Mop pads is not cleaned properly after use.

•

Clean the mop pads thoroughly after each use. Cleaning with a soiled mop may 

make the floor dirtier.