Пылесос Karcher DS 6 Premium Plus - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
– 7
Illustration
Add one cap full of the defoaming liquid (Foam-
Stop) to the water filter reservoir.
Note
: The functioning of the vacuum cleaner is
based on the whirling of the suction air in the water
filter. In the process, sucked-in materials and de-
posits of cleaning agents from floors get collected
in the water bath. This can sometimes lead to the
formation of foam. It is necessary to add a capful of
the defoamer liquid to the water bath to avoid this
situation. Slight foam formation is normal and does
not hamper the functioning of the machine.
Illustration
Note
: Please refill water as soon as the water level
in the reservoir sinks below the MIN mark.
Insert the baffle plate and reattach the lid of the wa-
ter filter container. Install the complete water filter
container in the appliance.
Illustration
Pull the power cable out of the appliance complete-
ly.
Illustration
Insert the appliance plug into the mains socket.
To switch on the appliance press the on/off switch.
Caution
Do not vacuum up large amounts of powdery materials
such as cocoa, flour, laundry detergent, pudding pow-
der or similar materials!
Illustration
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are extended.
Illustration
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are retracted.
Note
Due to the high suction power of the appliance, the suc-
tion nozzles can draw themselves too firmly to carpets,
upholstery, etc. during work. In this case, use the false
air slide to reduce the suction power. Close it again after
use.
Note
: The crevice and upholstery nozzles are stored in
the appliance.
Illustration
Open the accessories flap and take out the desired
nozzle for working.
for edges, joints, heaters and hard to reach locations.
for cleaning upholstered furniture, laced curtains, mat-
tresses, etc.
Illustration
Note
There are two symbols on the floor nozzle for adjust-
ment to high and short pile carpets.
Slide the slider to the left (high pile carpet) or right
(short pile carpet) as required.
There is not electrical outlet necessary.
Illustration
Switch off the appliance; press the on/off foot
switch to do so.
Illustration
Insert the floor nozzle into the pickup on the appli-
ance when taking a break.
Illustration
Turn off the appliance and disconnect the mains
plug.
Illustration
The cable is automatically retracted into the appli-
ance by slightly pulling on the power cord.
Caution
Rinse the water filter container, the filter cover and the
baffle plate under running water after each use and al-
low them to dry. Make sure that the guides of the baffle
plate are also clean.
Illustration
Remove the water filter reservoir from the appli-
ance (see: FILLING THE WATER FILTER RESER-
VOIR).
Illustration
Remove the lid from the reservoir and take out the
baffle plate.
Empty the water filter container.
Rinse the cover, the baffle plate and the water filter
container under running water and allow them to
dry.
Illustration
Clean/rinse the intermediate filter as necessary.
(see: CARE, MAINTENANCE)
Caution
All parts of the water filter must be properly dried prior
to assembly!
Caution
Prior to storing the appliance, ensure that no water re-
mains in the water filter container and all parts of the wa-
ter filter system are properly dried.
Hold the appliance at the carrying handle when you
want to transport it and store it in dry rooms.
Illustration
The appliance can be stored in an upright position.
On the bottom of the appliance there is an addition-
al parking position for the floor nozzle.
Note
: Clean the intermediate filter at least every 8
weeks with normal use. If the suction performance is de-
teriorating, the filter must be cleaned sooner.
Start working
Working with the floor nozzle
Vacuuming hard surfaces
Vacuuming carpeted floors
Working with the crevice nozzle and the
upholstery nozzle
Crevice nozzle
Upholstery nozzle
Turbo floor nozzle
Park position
Finish operation
Cleaning the water filter system
Transport, storage
Maintenance and Care
Cleaning/replacing the intermediate filter
12
EN
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)