Philips FC8432 - Инструкция по эксплуатации - Страница 6

6

important

Read these instructions for use carefully before using the appliance and save them for future 

reference.

Check if the voltage indicated on the appliance corresponds to the local mains voltage before 

you connect the appliance.

Do not use the appliance if the plug, the cord or the appliance itself is damaged.

If the mains cord is damaged, it must be replaced by Philips, a ser vice centre authorised by 

Philips or similarly qualified persons in order to avoid a hazard.

Keep the appliance out of the reach of children.

Never suck up water or any other liquid. Never suck up flammable substances and do not suck 

up ashes until they are cold.

Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum cleaner is 

switched on and the hose is connected to the vacuum cleaner. 

When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become 

clogged, causing the passage of air through the dustbag to become obstructed. As a result, the 

dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the 

dustbag is not full at all (see chapter ‘Replacing the dustbag’).

Never use the appliance without the Motor Protection Filter. This could damage the motor and 

shor ten the life of the appliance.

Only use Philips s-bag 

`

 double-layer paper dustbags. 

Noise level: Lc = 80 dB [A]

electromagnetic fields (eMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled 

properly and in accordance with the instructions in this instruction manual, the appliance is safe to 

use according to scientific evidence available today.

Preparing for use

Connecting accessories

Hose

  1 

 To connect the hose to the appliance, push it into the appliance and turn it clockwise (Fig. 1).

  2 

 To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the 

appliance.

tube
Conical coupling (specific types only)

  1 

 To connect the tube to the handgrip, insert the narrow section into the wider section while 

turning it a little (Fig. 2).

  2 

 To disconnect the tube, pull while turning it a little.

Use the same methods to connect the accessories to or to disconnect them from the tube or 

handgrip.

Button coupling (specific types only)

  1 

 Connect the tube to the handgrip (‘click’) (Fig. 3).

  2 

 To disconnect the tube from the handgrip, push the lock button and pull the tube out of the 

handgrip.  (Fig. 4)

Use the same methods to connect the accessories to or to disconnect them from the tube or 

handgrip.

-

-

-

-

-

-

-

-

-

-

EngLish