Miele SBAD3 Classic C1 Parquet - Инструкция по эксплуатации - Страница 46

en

46

Replace these exhaust filters if the
timestrip

®

 filter change indicator is

completely red (Fig. 12).
The display will be completely filled with
red after approximately 50 operating
hours; this corresponds to approxim-
ately one year of average use. You can
continue vacuuming when the light
comes on. However, the suction power
will be reduced as will the effectiveness
of the filter if it is not replaced in good
time.



Open the dust compartment lid.



Lift the exhaust filter and remove it.



Insert a new exhaust filter, making it
sure it goes in properly, then push it
down into position.



Press the timestrip

®

 filter change in-

dicator on the exhaust filter (Fig. 10).

After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 11).

If you wish to fit an AirClean exhaust
filter, see “Replacing one type of ex-
haust filter with another”.



Close the dust compartment lid.

Replacing one type of exhaust filter
with another (Fig. 07)

Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:

a AirClean

b Active AirClean 30 (black)

c HEPA AirClean 30 (white)

Do not use more than one exhaust
filter at a time.

When changing the filter, please note

1. If you wish to replace exhaust filter 

a

with exhaust filter 

b

 or 

c

, it is essen-

tial that you remove the filter grille
before you fit the new exhaust filter.

You must also activate the timestrip

®

filter change indicator on the exhaust
filter (Fig. 10).

2. If you wish to replace exhaust filter 

b

or 

c

 with exhaust filter 

a

, it is essen-

tial that you also fit the filter grille*
(Fig. 26).

* Filter grille – see “Optional ac-
cessories”

Replacing the thread lifters
(Fig. 28 + 29)

The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.



Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.



Fit new thread lifters.

Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.