Dreame Cordless Vacuum Cleaner V10 White (VVN3) - Инструкция по эксплуатации - Страница 6

1. The 2-in-1 charging & storage mount is an optional accessory, you can install it 

based on your requirements.
2. The mount should be installed in a cool, dry place near a power outlet, out of 

direct sunlight, and away from moisture-prone areas, such as a kitchen.
3. Securely install the mount using mounting hardware suitable for the type of wall 

selected. Make sure the installation area is clear of any pipes such as gas or water 

lines, and air ducts, electric wires and cables, or drainage lines.
4. It is recommended to hire a professional to install the mount and to use protective 

clothing, goggles, and other protective equipment where necessary.
5. Using an electric drill, mark and drill two 8 mm diameter holes into the wall where 

desired to a depth of about 30 mm. Insert the wall plugs into the holes, position the 

mount, then fasten it to the wall with the included screws.

106cm

Installation

Installing the 2-in-1 Charging & Storage Mount

1. Fully charge the vacuum before using it for the first time. This will take about 4 

hours.
2. Vacuum cannot be used while charging.
3. Vacuuming at turbo mode for a prolonged period will cause the battery to heat up, 

which increases charging time. Allow the vacuum to cool down for 30 minutes before 

charging it.

How to Use 

Note:

Battery Status Indicator

Please read the Safety Instructions in this user manual before proceeding.

Low battery
Half battery
Nearly full

Fully charged
Fully charged

Note: Once the vacuum is fully charged, the indicator will turn off after 5 

minutes, and the vacuum will enter the energy-saving mode.

Off

Blinking

On

7

8