Clatronic BS 1292 - Инструкция по эксплуатации - Страница 27

27

Air Slide
Open the air slide on the hose handle in order 

to regulate the airflow or to clear any particles 

sticking to the nozzle.

Switching off and Winding up the Mains Lead
1.  Turn the vacuum cleaner off by the on/off switch and 

remove the plug from the socket. 

2.  Keep the plug in your hand.

3.  Press the cable winding button and guide the cable. Hold 

the cable to avoid wrapping.

Maintenance

Dust bag replacement display (8)
Hold the hose up into air. If the display for the vacuum bag 

change shows “red”, the dust bag is full. Please change it.

Changing the dust bag
1.  Pull the plug out of the socket.

2.  Use the opener (6) to open the lid of the dust-bag compart-

ment.

3.  Open the lock that holds the dust-bag. Remove the dust-

bag. 

4.  Insert a new dust-bag. Slide the opening of the dust-bag 

onto the inside hose connection. 

5.  Fix the dust-bag in place with the locking mechanism. 

  The bag must be located completely in the dust bag com-

partment. Close the cover so that it snaps into place.

Filter
Your appliance has two filters.

Motor protection filter (inlet filter) 

The inlet filter is located in the dust bag compartment. The 

filter is located vertically in the rear section of the dust housing. 

Remove the filter by pulling upwards.

Cleaning the Filter Element

Clean the engine protection filter after 10 dust bag changes. If 

necessary, the filter can also be washed in warm water without 

any additives. Place it back into place only once it is completely 

dry!

Outlet filter 

The appliance is also equipped with an outlet filter. 
It is located on the rear of the device under the parking aid.
1.  Press the lever to the left and remove the ventilation grille.

2.  Remove the filter insert and clean it as described above.

3.  Place the completely dry filter back into the ventilation grille.

4.  Put the ventilation grille back on the appliance. Observe the 

guide lugs. The ventilation grid must engage audibly. 

Cleaning 

WARNING:

•  Before cleaning remove the mains lead from the socket.

•  Under no circumstances should you immerse the device in water 

for cleaning purposes. Otherwise this might result in an electric 

shock or fire.

CAUTION: 

•  Do not use a wire brush or any abrasive items.

•  Do not use any acidic or abrasive detergents.

Clean the housing with a soft, dry cloth without additives.

Storage 

•  Let the device cool down completely. 

•  Wind the cable completely.

•  Please insert the hook of the floor nozzle into the parking 

assistant on the rear of the device.

Troubleshooting

•  The Device Does Not Work.

Remedy:

Check the connection to the mains.

Check the position of the switch.

•  The device does not suck up anything.

Possible Cause:

The dust bag is full.

Remedy:

Renew the dust bag.
or 

Possible Cause:

The filters are dirty.