Bosch Flexxo Serie | 4 25.2V BCH3K255 - Инструкция по эксплуатации - Страница 43

41

Fig. 

12 

‡

Remove the hand-held cordless vacuum cleaner 
from the hand stick. 

Fig. 

7

‡

Using the release button, unlock the dust container 
and remove it from the motor unit.

Fig. 

13 

‡

Take the filter unit out of the dust container.

‡

Empty the dust container.

Fig. 

14 

‡

Remove any dir t which may have been lodged under-
neath the container ejector opening.

a) 

Inser t the filter unit into the dust container, making 
sure it is correctly seated

b) 

Inser t the dust container in the appliance, so that it 
'clicks' audibly into place

!

 Caution: 

If you notice any resistance when inserting 

the dust container, check that the filter is complete 
and that the filter unit and dust container are correct-
ly seated. 

Cleaning the filter

The outer filter unit and filter cartridge should be clea-
ned at regular inter vals in order to ensure optimum 
operation of the vacuum cleaner.

!

Caution:

 The filter can only be cleaned if the appli-

ance is switched off.

Never vacuum without the outer filter unit and its 
fitted filter car tridge.

Fig. 

15 

 Cleaning the outer filter unit

‡

Switch off the appliance. 

Fig. 

11

‡

Remove the hand-held cordless vacuum cleaner 
from the hand stick. 

Fig. 

7

‡

Using the release button, unlock the dust container 
and remove it from the motor unit. 

Fig. 

12

‡

Take the filter unit out of the dust container.

a) 

It is usually sufficient to lightly shake or tap out the 
whole filter unit when the dust container is emptied in 
order to dislodge any particles of dirt.

b) 

If this is not sufficient, you can use a dry cloth to remo-
ve dirt particles from the surface.

Fig. 

16 

 Cleaning the filter cartridge

a) 

Remove the filter cartridge from the filter unit.

b) 

Firstly, clean the filter cartridge by tapping out the dirt.

c) 

Pull out the foam filter from the motor protection and 
rinse separately. 

 Allow the foam filter and motor protection filter to 
dr y completely (approx. 24 hours)

‡

After fitting the foam filter, insert the filter unit into the 
dust container.

New filters can be obtained from our after-sales ser-
vice, if required.

Cleaning the floor nozzle

Before carr ying out any maintenance, switch off the 
vacuum cleaner and disconnect it from the charging 
cable.

Fig. 

17 

‡

Use the release button to release the brush roller 
and pull it sideways out of the floor nozzle.

‡

Using the groove provided, cut through threads and 
hairs wound round the rollers with scissors.

‡

Push the brush roller in sideways along the guide rod 
in the floor tool and lock in place using the release 
button.

! 

  Caution: The floor nozzle must only be put into 

operation with the brush roller fitted.

! 

 Caution: 

   Floor nozzles are subject to a cer tain amount of 

wear, depending on the type of hard floors you have 
(e.g. rough, rustic tiles). You must therefore check 
the underside of the floor tool at regular inter vals. 
Worn undersides of floor nozzles may have sharp 
edges that can damage delicate hard floors, such as 
parquet or linoleum. The manufacturer does not ac-
cept any responsibility for damage caused by worn 
floor tools.

Care

Before cleaning the hand stick vacuum cleaner or hand-
held cordless vacuum cleaner, it must be switched off 
and disconnected from the charging cable. The vacuum 
cleaner and accessories can be cleaned using a stan-
dard commercially-available plastic cleaner.

!

 Caution: 

Do not use abrasive materials, glass-

cleaning agents or all-purpose cleaning products. 
Never immerse the vacuum cleaner in water.

Subject to technical modifications.

* Depending on model