Philips SRU5030 - Инструкция по эксплуатации - Страница 5

4

Press and hold the Standby key of the 
SRU 5030.

–

The SRU 5030 now star ts emitting all known 
‘TV off ’ signals, one by one.
Each time a code is sent, the TV key lights up.

5

When your TV switches off (stand-by), release the Standby key of the
SRU 5030 immediately.

–

The SRU 5030 has now found a code that works on your TV.

6

Check if you can operate all functions on your TV with the SRU 5030.

•

If this is not the case, you can redo the automatic setting.
The SRU 5030 will then search for a code that works better.

–

After the SRU 5030 has run through all the known codes, the search
will stop automatically and the TV key stops flashing.

–

Automatic programming of a TV takes a maximum of 5 minutes.
For DVD and VCR this time is 2 minutes.

Manually setting the remote control

Example of TV:

1

Turn on the TV manually or use the original remote control.
Tune in to channel 1.

2

Look up the brand of your TV in the 
code list at the back of this manual.
One or more four-figure codes are shown for
each brand.
Note the first code.

Be careful! There are separate tables for TV, DVD
and VCR.

On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.

Make sure you use the codes from the correct table.

3

Press the TV key to select TV.
Press the key until it lights up.

4

Keep keys 1 and 3 

pressed simultaneously 

for three seconds

until the TV key flashes

twice and then remains lit.

6

Instructions for use

English