Philips SRU1010 - Инструкция по эксплуатации - Страница 5

Automatically setting the remote control

If you cannot find the right code for your brand device, the remote control can automatically search for the
right code.

1

Make sure the TV is switched on and select a channel using the original remote control or the keys on
the TV (for example channel 1).

2

Keep keys 

s

and 

y

on the SRU 1010 pressed simultaneously for 

five seconds, until the indicator light remains lit.

3

Press the 

y

key of the SRU 1010 and keep it pressed.

–

The SRU 1010 now star ts emitting all known ‘TV off ’ signals, one by one.
Each time a code is sent, the indicator light flashes.

4

When your TV switches off (stand-by), immediately release the 

y

key of the 

SRU 1010 to confirm.

–

The SRU 1010 has now found a code that works on your TV.

5

Check if you can operate all functions on your TV with the SRU 1010.

•

If this is not the case, you can redo the automatic setting.
The SRU 1010 will then search for a code that perhaps works better.

–

After the SRU 1010 has run through all the known codes, the search will stop automatically and the
indicator light stops flashing.

–

Automatic programming of a TV takes a maximum of 6 minutes.

6

ENGLISH