Kuppersberg GS 4502 - Инструкция по эксплуатации - Страница 7

7

ENGLISH

TECHNICAL PASSPORT

Dishwasher

Dishwasher Features

Front View

1 Upper Basket

2 Spray Arms

3 Lower Basket

4 Water Softener

5 Filters

6 Detergent Dispenser

7 Rinse Aid Dispenser

8 Cutlery basket

4.  P R I O R  U S I N G 

F O R  T H E  F I R S T  T I M E

Before using your dishwasher 

for the fi rst time:

A. Set the water softener
B. Loading the salt into the softener
C. Fill the rinse aid dispenser
D. Fill in detergent

А. Set the Water Softener

The water softener is designed to 

remove minerals and salts from the 
water, which would have a detrimental 

or adverse effect on the operation of 
the appliance. The higher the content 
of these minerals and salts, the harder 
the water is. The softener should be 
adjusted according to the hardness 
of the water in your area. Your local \
Afeiter Authority can advise you on the 
hardness of the water in your area.

Setting

The amount of salt dispensed can be 

set from HO to H7.

Salt is not required at the set value 

HO.
1.  Find out about the hardness value 

of your tap water. Your water utility 
company will help you with this.

2.  Set value can be found in the water 

hardness table.

3.  Close the door.
4.  Switch on «Power» switch.
5.  Hold down « Delay» button and 

then press «Program» button for 
5 seconds.The buzzer rings one 

time and H. . fl ashes on the digital 

display.(factory setting is H4)

To change the setting:

1.  Press « Delay « button. Each time 

the button is pressed, the set value 
increasesby one level;when the 
value of H7 has been reached, the 
display jumps back to HO(off).

2.  Press « Program « button. The 

chosen setting has now been stored. 

 Contact your local water board for 

infor mation on the hardness of your 

water supply.