Kuppersberg GS 4502 - Инструкция по эксплуатации - Страница 21

21

ENGLISH

TECHNICAL PASSPORT

Dishwasher

NOTE: I

f operate from step 1 to step 

2,  the  fi lter  system  will  be  removed; 

while operate from step 2 to step 1, the 

fi lter system will be installed 

3

.

 Filter  assembly

For best performance and results, 

the fi lter assembly must be cleaned. The 

fi lter  effi ciently  removes  food  particles 

from the wash water, allowing it to be 

recirculated during the cycle. For this 

reason, it is a good idea to remove the 

larger food particles trapped in the 

fi lter  after  each  wash  cycle  by  rinsing 

the  semicircular  fi lter  and  cup  under 

running  water.  To  remove  the  fi lter 

assembly, pull on the cup handle in 

the  upward  direction.  The  entire  fi lter 

assembly should be cleaned once a 

week. To clean the coarse fi lter and the 

micro fi lter, use a cleaning brush. Then, 

reassemble the fi lter parts as shown in 

the fi gures above and reinsert the entire 

assembly in the dishwasher, positioning 

in its seat and pressing downward. The 

dishwasher must never be used without 

the fi lters. Improper replacement of the 

fi lter may reduce the performance level 

of the appliance and damage dishes 

and utensils.

WARNING!

Never run the dishwasher without 

the  fi lters  in  place.  When  cleaning  the 

fi lters,  don’t  knock  on  them.  Otherwise, 

the  fi lters  could  be  contorted  and  the 

performance of dishwasher could be 

debased.

Cleaning the Spray Arms

It is necessary to clean the spray 

arms regularly for hard water chemicals 

will clog the spray arm jets and bearings.

To remove the spray arms, screw 

off the nut clockwise to take out the 

washer on top of the spray arm and 

remove the arm. Wash the arms in soapy 

and warm water and use a soft brush 

to clean the jets. Replace them after 

rinsing thoroughly.