Simfer F96MW52001 - Инструкция по эксплуатации - Страница 39

39

Cleaning And Maintenance Of The Oven’s Front Door Glass

Remove the profile by pressing the plastic latches on both left and right 

sides  as  shown  in  figure  21  and  pulling  the  profile  towards  yourself  as 
shown in figure 22. Then remove the inner-glass as shown in figure 23. 

If required, middle glass can be removed in the same way. After cleaning 

and maintenance are done, remount the glasses and the profile in reverse 
order.Make sure the profile is properly seated in its place.

Catalytic Walls *

Catalytic walls are located on the left and the right side of cavity under the 

guides. Catalytic walls banish the bad smell and obtain the best performance 
from the cooker. Catalytic walls also absorb oil residue and clean your oven 
while it’s operating. 

Removing the catalytic walls

In order to remove the catalytic walls; the guides must be pulled out. 

As soon as the guides are pulled out, the catalytic walls will be released 
automatically. The catalytic walls must be changed after 2-3 years.  

Rack Positions *

It is important to place the wire grill into 

the oven properly. Do not allow wire rack to 

touch rear wall of the oven. Rack positions 

are shown in the next figure. 

You may place 

a deep tray or a standard tray in the lower 
and upper wire racks.

Installing and removing wire racks

To  remove  wire  racks,  press  the  clips  shown  with  arrows  in  the  figure, 

first remove the lower, and than the upper side from installation location. 

To install wire racks; reverse the procedure for removing wire rack.

Figure 21

Figure 22

Figure 23

Rack 4
Rack 3
Rack 2
Rack 1