Simfer F96MW52001 - Инструкция по эксплуатации - Страница 20

20

Reduced gas flow rate setting for hob taps

1.

 Ignite the burner that is to be adjustment and turn the knob to the 

reduced position.

2.

 Remove the knob from the gas tap.

3. 

Use an appropriately sized screwdriver to adjust the flow rate adjustment 

screw. For LPG (butane-pro pane) turn the screw clockwise. For the 
naturel gas, you should turn the screw counter- clockwise once.

“The  normal  length  of  a  straight  flame  in  the  reduced  position  should 

be 6-7 mm.“

4.

 If the flame is higher then the desired position, turn the screw clockwise. 

If it is smaller turn anticolockwise.

5.

 For the last control, bring the burner both to higt-flame and reduced 

positions and check whether the flame is on or off.

Depending on the type of gas tap used in your appliance the adjustment 

screw position may vary. 

To adjust your oven acc. to the gas type, make the adjustment for 

reduced flame carefully by turning with a small screwdriver as shown 

below on the screw in the middle of the gas cocks as well as nozzle 

changes (figure 6 and 7).

Figure 6

Figure 7

GB