Simfer F66GH42117 - Инструкция по эксплуатации - Страница 16

16

Gas Connection

WARNING:  

Before starting any work related with gas installation, turn off 

gas supply. Risk of explosion.

Please operate your oven in dry atmosphere.

1. 

Fit the clamp to the hose. Push one of the hose until it goes to the 

end of the pipe.

2. 

For the sealing control; ensure that the buttons in the control panel are 

closed, but the gas cylinder is open. Apply some soap bubbles to the 
connection. If there is gas leakage, there will be foaming in the soaped area.

3. 

The oven should be using a well ventilation place and should be        

install on flat ground.

4. 

Re-inspect the gas connection.

5. 

When placing your oven to its location, ensure that it is at the counter 

level. Bring it to the counter level by adjusting the feet if necessary.

6. 

Do not make gas hose and electrical cable of your oven go through theheated 

areas, especially through the rear side of the oven. Do not move gas connected 
oven. Since the forcing shall loosen the hose, gas leakage may occur.

7. 

Please use flexible hose for gas connection. 

For LPG connection;

For  LPG  (cylinder)  connection,  affix  metal 

clamp on the hose coming from LPG 

cylinder. Affix an edge of the hose on hose 

inlet connector behind the appliance by 
pushing to end through heating the hose 
in boiled water. Afterward, bring the clamp 
towards end section of the hose and tighten 
it with screwdriver. The gasket and hose inlet 
connector required for connection is as the 
picture shown below.

NOTE:

  The  regulator  to  be  affixed  on  LPG  cylinder  should  have  300 

mmSS feature.

Main Gas Pipe

Gasket

Hose Inlet Connector

Metal Clamp

Lpg Connection Hose

GB