Smeg B901GMXI9 - Инструкция по эксплуатации - Страница 6

Instructions

54

• Installation using a hose must be 

carried out so that the length of 
the hose does not exceed 
2 metres when fully extended for 
steel hoses and 1.5 metres for 
rubber hoses.

• The hoses should not come into 

contact with moving parts and 
should not be crushed in any way.

• If required, use a pressure 

regulator that complies with 
current regulations.

• After carrying out any operation, 

check that the tightening torque of 
gas connections is between 
10 Nm and 15 Nm.

• At the end of the installation, 

check for any leaks with a soapy 
solution, never with a flame.

• Have the electrical connection 

performed by authorised 
technicians.

• The appliance must be connected 

to ground in compliance with 
electrical system safety standards.

• Use cables withstanding a 

temperature of at least 90 °C.

• The tightening torque of the 

screws of the terminal board 
leads must be 1.5 - 2 Nm.

•  Before installation, make sure that 

the local distribution conditions 
(nature and pressure of the gas) 
and the adjustment of the 

appliance are compatible;

•  The adjustment conditions for this 

appliance are shown on the gas 
setting label. 

• This appliance is not connected to 

an exhaust system for combustion 
products. It must be installed and 
connected in compliance with the 
current installation regulations. 
Special attention should be paid 
to the relevant requirements as for 
ventilation.

For this appliance

• Ensure that the appliance is 

switched off before replacing the 
bulb.

• Do not rest any weight or sit on 

the open door of the appliance.

• Take care that no objects are 

stuck in the doors.

1.2 Manufacturer liability

The manufacturer declines all liability 
for damage to persons or property 
caused by:
•  Use of the appliance other than 

that specified;

•  failure to comply with the 

instructions in the user manual;

•  tampering with any part of the 

appliance;

•  use of non-original spare parts.