Makita HS6100 - Инструкция по эксплуатации - Страница 7

7 

17. 

Never force the saw. Push the saw forward at a 
speed so that the blade cuts without slowing.

Forcing the saw can cause uneven cuts, loss of 
accuracy, and possible kickback. 

Lower guard function 

18. 

Check lower guard for proper closing before 
each use. Do not operate the saw if lower 
guard does not move freely and close instantly. 
Never clamp or tie the lower guard into the 
open position.

 If saw is accidentally dropped, 

lower guard may be bent. Raise the lower guard 
with the retracting handle and make sure it moves 
freely and does not touch the blade or any other 
part, in all angles and depths of cut. 

19. 

Check the operation of the lower guard spring. 
If the guard and the spring are not operating 
properly, they must be serviced before use.

Lower guard may operate sluggishly due to 
damaged parts, gummy deposits, or a build-up of 
debris. 

20. 

Lower guard may be retracted manually only 
for special cuts such as "plunge cuts" and 
"compound cuts". Raise lower guard by 
retracting handle and as soon as blade enters 
the material, the lower guard must be released.

For all other sawing, the lower guard should 
operate automatically. 

21. 

Always observe that the lower guard is 
covering the blade before placing saw down on 
bench or floor.

 An unprotected, coasting blade will 

cause the saw to walk backwards, cutting whatever 
is in its path. Be aware of the time it takes for the 
blade to stop after switch is released. 

22. 

To check lower guard, open lower guard by 
hand, then release and watch guard closure. 
Also check to see that retracting handle does 
not touch tool housing.

 Leaving blade exposed 

is VERY DANGEROUS and can lead to serious 
personal injury. 

Additional safety warnings 

23. 

Use extra caution when cutting damp wood, 
pressure treated lumber, or wood containing 
knots.

 Maintain smooth advancement of tool 

without decrease in blade speed to avoid 
overheating the blade tips. 

24. 

Do not attempt to remove cut material when 
blade is moving. Wait until blade stops before 
grasping cut material.

Blades coast after turn off. 

25. 

Avoid cutting nails. Inspect for and remove all 
nails from lumber before cutting. 

26. 

Place the wider portion of the saw base on 
that part of the workpiece which is solidly 
supported, not on the section that will fall off 
when the cut is made. As examples, Fig. 1 
illustrates the RIGHT way to cut off the end of 
a board, and Fig. 2 the WRONG way. If the 
workpiece is short or small, clamp it down. DO 
NOT TRY TO HOLD SHORT PIECES BY HAND! 

Fig. 1

000147 

Fig. 2

000150 

27. 

Before setting the tool down after completing 
a cut, be sure that the lower guard has closed 
and the blade has come to a complete stop. 

28. 

Never attempt to saw with the circular saw 
held upside down in a vise. This is extremely 
dangerous and can lead to serious accidents. 

000029 

29. 

Some material contains chemicals which may 
be toxic. Take caution to prevent dust 
inhalation and skin contact. Follow material 
supplier safety data. 

30. 

Do not stop the blades by lateral pressure on 
the saw blade. 

31. 

Always use blades recommended in this 
manual. Do not use any abrasive wheels. 

32. 

Keep blade sharp and clean.

 Gum and wood 

pitch hardened on blades slows saw and 
increases potential for kickback. Keep blade clean 
by first removing it from tool, then cleaning it with