Makita DSS610RF - Инструкция по эксплуатации - Страница 7

7 

Additional safety warnings 

23. 

Use extra caution when cutting damp wood, 
pressure treated lumber, or wood containing 
knots.

 Maintain smooth advancement of tool 

without decrease in blade speed to avoid 
overheating the blade tips. 

24. 

Do not attempt to remove cut material when 
blade is moving. Wait until blade stops before 
grasping cut material.

Blades coast after turn off. 

25. 

Avoid Cutting Nails. Inspect for and remove 
all nails from lumber before cutting. 

26. 

Place the wider portion of the saw base on 
that part of the workpiece which is solidly 
supported, not on the section that will fall off 
when the cut is made. As examples, Fig. 1 
illustrates the RIGHT way to cut off the end of 
a board, and Fig. 2 the WRONG way. If the 
workpiece is short or small, clamp it down. 
DO NOT TRY TO HOLD SHORT PIECES BY 
HAND! 

000163 

Fig. 2

000190 

27. 

Before setting the tool down after completing 
a cut, be sure that the lower guard has closed 
and the blade has come to a complete stop. 

28. 

Never attempt to saw with the circular saw 
held upside down in a vise. This is extremely 
dangerous and can lead to serious accidents. 

000029 

29. 

Some material contains chemicals which may 
be toxic. Take caution to prevent dust 
inhalation and skin contact. Follow material 
supplier safety data. 

30. 

Do not stop the blades by lateral pressure on 
the saw blade. 

31. 

Always use blades recommended in this 
manual. Do not use any abrasive wheels. 

32. 

Keep blade sharp and clean.

 Gum and wood 

pitch hardened on blades slows saw and 
increases potential for kickback. Keep blade 
clean by first removing it from tool, then cleaning 
it with gum and pitch remover, hot water or 
kerosene. Never use gasoline. 

33. 

Wear a dust mask and hearing protection 
when use the tool. 

SAVE THESE INSTRUCTIONS. 

WARNING: 

DO NOT let comfort or familiarity with product 
(gained from repeated use) replace strict adherence 
to safety rules for the subject product. MISUSE or 
failure to follow the safety rules stated in this 
instruction manual may cause serious personal 
injury. 

ENC007-7 

IMPORTANT SAFETY 
INSTRUCTIONS 
FOR BATTERY CARTRIDGE 

1. 

Before using battery cartridge, read all 
instructions and cautionary markings on (1) 
battery charger, (2) battery, and (3) product 
using battery. 

2. 

Do not disassemble battery cartridge. 

3. 

If operating time has become excessively 
shorter, stop operating immediately. It may 
result in a risk of overheating, possible burns 
and even an explosion. 

4. 

If electrolyte gets into your eyes, rinse them 
out with clear water and seek medical 
attention right away. It may result in loss of 
your eyesight.