Makita DSS610RF - Инструкция по эксплуатации - Страница 6

6 

the blade comes to a complete stop. Never 
attempt to remove the saw from the work or 
pull the saw backward while the blade is in 
motion or kickback may occur.

 Investigate and 

take corrective actions to eliminate the cause of 
blade binding. 

11. 

When restarting a saw in the workpiece, centre 
the saw blade in the kerf and check that saw 
teeth are not engaged into the material.

 If saw 

blade is binding, it may walk up or kickback from 
the workpiece as the saw is restarted. 

12. 

Support large panels to minimise the risk of 
blade pinching and kickback.

 Large panels 

tend to sag under their own weight. Supports 
must be placed under the panel on both sides, 
near the line of cut and near the edge of the 
panel. 

To avoid kickback, do support 

board or panel near the cut.

000192 

Do not support board or 

panel away from the cut.

000191 

13. 

Do not use dull or damaged blades.

Unsharpened or improperly set blades produce 
narrow kerf causing excessive friction, blade 
binding and kickback. 

14. 

Blade depth and bevel adjusting locking 
levers must be tight and secure before 
making cut.

 If blade adjustment shifts while 

cutting, it may cause binding and kickback. 

15. 

Use extra caution when sawing into existing 
walls or other blind areas.

 The protruding blade 

may cut objects that can cause kickback. 

16. 

ALWAYS hold the tool firmly with both hands. 
NEVER place your hand or fingers behind the 
saw.

 If kickback occurs, the saw could easily 

jump backwards over your hand, leading to 
serious personal injury. 

000160 

17. 

Never force the saw. Push the saw forward at 
a speed so that the blade cuts without 
slowing.

 Forcing the saw can cause uneven cuts, 

loss of accuracy, and possible kickback. 

Lower guard function 

18. 

Check lower guard for proper closing before 
each use. Do not operate the saw if lower 
guard does not move freely and close 
instantly. Never clamp or tie the lower guard 
into the open position.

 If saw is accidentally 

dropped, lower guard may be bent. Raise the 
lower guard with the retracting handle and make 
sure it moves freely and does not touch the blade 
or any other part, in all angles and depths of cut. 

19. 

Check the operation of the lower guard spring. 

If the guard and the spring are not operating 
properly, they must be serviced before use.

Lower guard may operate sluggishly due to 
damaged parts, gummy deposits, or a build-up of 
debris. 

20. 

Lower guard may be retracted manually only 
for special cuts such as "plunge cuts" and 
"compound cuts". Raise lower guard by 
retracting handle and as soon as blade enters 
the material, the lower guard must be released.

For all other sawing, the lower guard should 
operate automatically. 

21. 

Always observe that the lower guard is 
covering the blade before placing saw down 
on bench or floor.

 An unprotected, coasting 

blade will cause the saw to walk backwards, 
cutting whatever is in its path. Be aware of the 
time it takes for the blade to stop after switch is 
released. 

22. 

To check lower guard, open lower guard by 
hand, then release and watch guard closure. 
Also check to see that retracting handle does 
not touch tool housing.

 Leaving blade exposed 

is VERY DANGEROUS and can lead to serious 
personal injury.