Philips PerfectCare Compact Plus GC7920/20 - Инструкция по эксплуатации - Страница 7

9

Storage

1 

Switch off the appliance and unplug it. 

Note: it is recommended to empty the water tank after every use. 

2 

Place the iron on the iron platform and lock it by pushing the carry lock release button (Fig. 22). 

3 

Fold the supply hose and wind the supply hose inside the supply hose storage compartment (Fig. 23). 

4 

Fold the mains cord and fasten it with the Velcro strip. 

5 

You can carry the appliance with one hand by the handle of the iron when the iron is locked on the iron 

platform. 

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you are 

unable to solve the problem with the information below, visit

 www.philips.com/support 

for a list of 

frequently asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not produce 

any steam.

There is not enough water in 

the water tank.

Fill the water tank. Press and hold the steam 

trigger until steam comes out. It may take up 

to 30 seconds until steam comes out.

You did not press the steam 

trigger.

Press and hold the steam trigger until steam 

comes out.

The steam function has 

been disabled until you have 

performed the Calc-Clean 

process.

Perform the Calc-Clean process to restore the 

steam function. (see chapter ‘Cleaning and 

maintenance’)

At the start of your ironing 

session, the steam trigger 

has not been pressed long 

enough.

Press and hold the steam trigger until steam 

comes out. It may take up to 30 seconds until 

steam comes out.

No steam comes out of 

the soleplate, the light of 

the CALC CLEAN button 

flashes and the appliance 

beeps.

You have not done or have 

not completed the Calc-

Clean process.

Perform the Calc-Clean process to enable the 

steam function again (see chapter ‘Cleaning 

and maintenance’).

Water droplets come out 

of the soleplate.

After the Calc-Clean process 

remaining water may drip 

out of the soleplate.

Wipe the soleplate dry with a piece of cloth. 

If the Calc-Clean light still flashes and the 

appliance still beeps, perform the Calc-

Clean process (see chapter ‘Cleaning and 

maintenance’).

You have used the steam 

boost function too 

frequently.

Use the steam boost function only for 

stubborn creases. It is recommended not to 

use it for more than 5 times within 3 minutes.

The Calc-Clean process has 

not been completed.

You have to perform the Calc-Clean 

process again (see chapter ‘Cleaning and 

maintenance’).

Steam condenses into water 

in the hose when you use 

steam for the first time or 

have not used it for a long 

time.

This is normal. Hold the iron away from the 

garment and press the steam trigger.Wait 

until steam instead of water comes out of the 

soleplate.

English