Philips FastCare Compact GC6742/20 - Инструкция по эксплуатации - Страница 8

10

Problem

Possible cause

Solution

The appliance has 

switched off.

The auto shut-off function is 

activated automatically. The 

appliance enters the standy 

mode if it has not been used for 

15 minutes and switches off if it 

has not been used for another 

10 minutes.

To swith on the appliance again, set the 

on/off switch to “off” position and then to 

“on” position.

The appliance produces a 

loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press 

the steam trigger until the pumping sound 

becomes softer and steam comes out of 

the soleplate.

Water droplets come out 

of the soleplate.

After the Calc-Clean process 

remaining water may drip out 

of the soleplate.

Wipe the soleplate dry with a piece of 

cloth. If the Calc-Clean light still flashes and 

the appliance still beeps, perform the Calc-

Clean process (see chapter ‘Cleaning and 

maintenance’).

The Calc-Clean process has not 

been completed.

You have to perform the Calc-Clean 

process again (see chapter ‘Cleaning and 

maintenance’).

Steam condenses into water in 

the hose when you use steam 

for the first time or have not 

used it for a long time.

This is normal. Hold the iron away from the 

garment and press the steam trigger.Wait 

until steam instead of water comes out of 

the soleplate.

Dirty water and impurities 

come out of the soleplate.

Impurities or chemicals present 

in the water have deposited 

in the steam vents and/or 

soleplate.

Perform the Calc-Clean process regularly 

(see chapter ‘Cleaning and maintenance’).

Steam condenses into water in 

the hose when you use steam 

for the first time or have not 

used it for a long time.

This is normal. Hold the iron away from the 

garment and press the steam trigger.Wait 

until steam instead of water comes out of 

the soleplate.

Water flushes out of the 

soleplate.

You have accidentally started 

the Calc-Clean process 

(see chapter 'Cleaning and 

maintenance').

Switch off the appliance. Then switch it 

back on again. Let the iron heat up until 

the ‘iron ready’ light lights up steadily.

The Calc-Clean process 

does not start.

You have not pressed the CALC-

CLEAN button for 2 seconds 

until the appliance started 

beeping.

See chapter ‘Cleaning and maintenance’.

The ironing board cover 

becomes wet, or there 

are water droplets on the 

floor/garment.

Steam has condensed on the 

ironing board cover after a long 

ironing session.

Replace the ironing board cover if the 

foam or felt material has worn out. You 

can also add an extra layer of felt material 

under the ironing board cover to prevent 

condensation on the ironing board.

You have an ironing board 

that is not designed to cope 

with the high steam rate of the 

appliance.

Put an extra layer of felt material under 

the ironing board cover to prevent 

condensation on the ironing board.

English