Seagate (ST6000VN001) - Инструкция по эксплуатации - Страница 10

Seagate IronWolf Product Manual, Rev. A

9  

www.seagate.com

Drive Specifications

*

All specifications above are based on native configurations.

** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. 

Accessible capacity may vary depending on operating environment and formatting.

*** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T.

specification, which may increase acoustic and power to operational levels.

†

Seagate does not recommend operating at sustained case temperatures above 60°C.
Operating at higher temperatures will reduce useful life of the product.

#

The operating case temperature is 0 to 70C (32 to 158F).
The recommended measure location can be found in 

Section 3.4

Figure 2

..

Wet bulb temperature (max)

30°C max (operating)

40°C max (non-operating)

Altitude, operating

–304m to 3048m

(–1000 ft to 10,000 ft)

Altitude, non-operating 
(below mean sea level, max)

–304m to12,192m

(–1000 ft to 40,000+ ft)

Operational shock (max)

70 Gs at 2ms

Non-operational shock (max)

250 Gs at 2ms

Vibration, operating

10Hz to 22Hz: 0.25 Gs, Limited displacement

22Hz to 350Hz: 0.50 Gs

350Hz to 500Hz: 0.25 Gs

Vibration, non-operating

5Hz to 22Hz: 3.0 Gs

22Hz to 350Hz: 3.0 Gs

350Hz to 500Hz: 3.0 Gs

Drive acoustics, sound power

Idle***

2.6 bels (typical)

2.7 bels (max)

Seek

2.7 bels (typical)

2.8 bels (max)

Non-recoverable read errors

1 per 10

14

 bits read

Rated workload

Average annualized workload rating: <180TB/year.
The specifications for the product assumes the I/O workload does not exceed the 
average annualized workload rate limit of 180TB/year. Workloads exceeding the 
annualized rate may degrade and impact reliability as experienced by the 
particular application. The average annualized workload rate limit is in units of TB 
per calendar year.

Warranty

To determine the warranty for a specific drive, use a web browser to access the 
following web page: 

http://www.seagate.com/support/warranty-and-replacements/

From this page, click on “Is my Drive under Warranty”. Users will be asked to 
provide the drive serial number, model number (or part number) and country of 
purchase. The system will display the warranty information for the drive.

Load/unload cycles

600,000 at 25°C, 50% rel. humidity 

Supports hotplug operation per the
Serial ATA Revision 3.2 specification

Yes

Note

If the drive is powered-off before issuing flush cache command, in some instances, 
the end user data in the DRAM cache might not be committed to the disk.

Table 1

Drive specifications summary  (continued)

Drive Specification*

ST6000VN001