Tefal Access Steam Force DT8270E1 - Инструкция по эксплуатации - Страница 89

7

6

•  To protect against a risk of electric shock, do not immerse the 

appliance in water or other liquids.

•  Do not direct steam at people, animals or clothes while they are being 

worn.

•  This appliance is not intended for use by persons (including children) 

with reduced physical, sensory or mental capabilities, or lack of 

experience and knowledge, unless they have been given supervision 

or instruction concerning use of the appliance by a person responsible 

for their safety. Children should be supervised to ensure that they do 

not play with the appliance.

•  The use of accessory attachments other than those provided by the 

manufacturer is not recommended and may result in fire, electric 

shock or personal injury.

•  The appliance must be used and placed on a flat, stable, heat-resistant 

surface. When you place the iron on the iron rest, make sure that the 

surface on which you place it is stable.

•  The appliance must not be used if it has been dropped, if it has any 

visible damage, if it leaks or if it functions abnormally in any way. Do 

not attempt to dismantle your appliance : have it examined at an 

approved service centre to avoid any danger.

•  Check the electrical power cord for sign of wear or damage prior to 

use. If the electrical power cord is damaged, it must be replaced at an 

approved service centre to avoid any danger.

•  Do not use other descaling products than the one cited in the IFU.

• To achieve optimal results in sanitizing , gently steam back and forth  

   3 times on the fabric.

Before first use

•  When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small 

discharge of particles. This will not affect the use of the appliance and will disappear quickly.

What water to use?

•  Your appliance has been designed to use untreated tap water. 

Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened water, rain water, 

filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners as these may damage the appliance. 

These types of water contain organic waste, mineral elements that become concentrated when heated and cause spitting, 

brown staining, leaking or premature wear on your appliance. If your water is very hard, mix 50% untreated tap water 

with 50% distilled water (available in hardware stores). This water contains organic waste materials or minerals that 

concentrate under the effect of heat and cause spitting, brown colouring or premature ageing of your appliance.

* 

EN

 Depending on model 

SAVE THESE INSTRUCTIONS

Environment protection first !

i

Your appliance contains valuable materials which can be recovered or recycled.



Leave it at a local civic waste collection point.

Problems with your garment steamer?

PROBLEM

POSSIBLE CAUSES

SOLUTIONS

There is no steam.

The appliance is not plugged in, or not 

switched on.

Check that your appliance is correctly 

plugged in and switched on.

The water level is too low.

Unplug your appliance and refill it.

The steam pump has not been primed.

Press the steam trigger continuously 

for a few seconds to begin steaming.

You are using the appliance for the first 

time.

Press the steam trigger continuously 

for a few seconds to begin steaming.

The water tank is not fully in place.

Ensure that stopper is closed and 

that the water tank snaps when put 

into place.

The appliance is on stand by mode* or 

auto-off*.

PLEASE REFER TO THE ‘STANDBY/

AUTO-OFF’ section.

The appliance does not 

heat.

It is not plugged in, or not switched on.

Plug in your appliance and switch on.

The appliance is on stand by mode* or 

auto-off*.

PLEASE REFER TO THE ‘STANDBY/

AUTO-OFF’ section.

Water leaks.

The water tank is not fully in place or the 

stopper is not closed properly.

Ensure that stopper is closed and 

that the water tank snaps when put 

into place.

Boost mode has been used too often 

(more than 3 times a minute)

Avoid using the boost more than 3 

times a minute.

Steam rate decreases.

Scale has built up in the appliance

Refer to ‘EASY DESCALING’ section in 

instructions for use. 

The steam leaves stains 

on the fabric or the 

appliance spits.

You are using water with additives.

Never add any additive in the water 

tank.

The appliance has not been cleaned 

enough after the descaling operation.

Read carefully the ‘EASY DESCALING’ 

section in instructions for use.

You are using other liquids than white 

vinegar to descale the product.

Use only white vinegar during ‘EASY 

DESCALING’ procedure.

Appliance steams 

continuously.

The steam trigger is on the lock position.

Unlock the steam trigger.

Micro-fiber brush* support 

is removed from the 

steam head. Micro-

fiber* is removed from 

the micro-fiber brush* 

support.

You scrub too tightly the textile.

Scrub softly the textile to remove 

impregnated dust.