Einhell TE-DH 50 - Инструкция по эксплуатации - Страница 19

GB

- 19 -

Check the lock by pulling on the tool.

5.3 Removing the tool

To remove the tool, follow the steps in reverse.

6. Operation

Danger!

To avoid danger, the machine must only be 

held using the two handles (1/3). 

Otherwise 

you risk an electric shock if you drill into electric 

cables.

6.1 ON/OFF switch (Fig. 5)

Switching on:

Move the ON/OFF switch (2) to the position „I“.

Switching o

ff

 :

Move the ON/OFF switch (2) to the position „O“.

6.2 Practical tips

6.2.1 Sharpening chisel tools

You will only achieve good results if you use sharp 

chisels. You should therefore sharpen the chisels 

promptly to ensure that they produce good results 

and provide a long service life.

Note:

You only require slight contact pressure for 

chiseling. Excessive contact pressure will place 

unnecessary strain on the motor. Check the 

chisels at regular intervals. Sharpen or replace 

blunt chisels.

7.  Replacing the power cable

Danger!

If the power cable for this equipment is damaged, 

it must be replaced by the manufacturer or its 

after-sales service or similarly trained personnel 

to avoid danger.

8.  Cleaning, maintenance and 

ordering of spare parts

Danger!

Always pull out the mains power plug before star-

ting any cleaning work.

8.1 Cleaning

• 

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

• 

 We recommend that you clean the device  

immediately each time you have finished 

using it.

• 

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

8.2 Carbon brushes

In case of excessive sparking, have the carbon  

brushes checked only by a quali

fi

 ed electrician.

Danger!

 The carbon brushes should not be rep 

laced by anyone but a quali

fi

 ed electrician.

8.3 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

8.4 Ordering spare parts and accessories

Please provide the following information when 

ordering spare parts:

• 

Type of unit

• 

Article number of the unit

• 

ID number of the unit

• 

Spare part number of the required spare part

For our latest prices and information please go to 

www.isc-gmbh.info

Tip! For good results we 

recommend high-quality ac-

cessories from 

! 

www.kwb.eu 

welcome@kwb.eu

Anl_TE_DH_50_SPK9.indb   19

Anl_TE_DH_50_SPK9.indb   19

12.09.2018   08:52:47

12.09.2018   08:52:47