Cooper&Hunter CH-D014WD2-30LD - Инструкция по эксплуатации - Страница 10

Operation Method

6

After 250 hours of operation, the 

Filter

 indicator light will glow to remind  

you to clean the filter. Remove the filter and clean it.

Press to rest to turn off the Filter light.See the.Clean and Maintenance.

2 

FILTER

NOTICE:

Water bucket must be correctly installed for the dehumidifier to operate.
Do not remove the bucket while unit is in operation.
If you want to use drain hose to drain water away, please install the hose 
according to section "Drainage  option".
Each time pressing the effective button on the control panel will give out a

   "beep" sound.

When power is connected, power indicator on the control panel will be on and
dehumidifier gives out a “beep” sound simultaneously.

1

Basic Functions of the Buttons

POWER 

Press to turn the dehumidifier on and off.

3

-/+

The humidity level can be set within a range of 80% RH (Relative Humidity) 
to

.

 35% RH (Relative Humidity) in 5% reduce or at continuous operation.To 

set the unit for continuous operation, press the - pad until the screen reads CO. 

NOTE:

 If 

Cont

 is selected, the dehumidifier will operate continuously at its 

maximum dehumidification settings if attached to a hose to drain or until the  
bucket is full.For drier air, press the - pad and set to a lower percent value (%). 

Full light indicates
bucket needs to be emptied 
or is not in place in the unit

Full

Cont operation 
on indicator light

High, Medium
and Low fan
indicator lights

Filter
indicator light

Low

Medium

High

  Cont

Filter

FILTER

4

hour

2

hour

TIMER

Power On
indicator light

On

P

POWER

For damper air, press the + pad and set to a higher percent value (%). 
When you first use the dehumidifier, set the humidity control to 45% or 50%. 
Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you 

2 hour

、

4 hour or 6 hour 

delay on/off indicator lights