Timberk TOR 21.2512 - Инструкция по эксплуатации - Страница 5

www.timberk.com • electric oil filled radiator

5

Fig. 2                  Fig. 3                   Fig. 4                   Fig. 5 

IMPORTANT! 

1. Switch on and operate the radiator only when upright (with 

wheels below and control elements above). Any other position 

may cause a dangerous situation and result in failure of the oil-

filled radiator or damage of property and the manufacturer will 

consider this as a non-warranty case.
2. Do not switch the radiator on, if roller wheels are not installed.

1. Read section «Important precautions» carefully unless you already did it.
2. Connect the unit’s power cord to an electric outlet, observing all of the 

abovementioned precautions. Remember that you can connect the unit 

to electric mains only if the rotating power regulator is in OFF position 

(switched off), i.e. the knob is rotated against the stop counterclockwise.
3. It is also preferable to turn the temperature regulating knob against the 

stop counterclockwise. Then you can connect the unit to electric mains.
4. Set the unit’s power regulator (knob) to position I, II or III (corresponds to 

low, normal and maximum power of unit’s operation). Remember that the 

higher the power you choose, the faster the unit heats the air. But at a low 

power you save electric power and reduce the load on your electric mains.
5. After you chose the desired operating power in accordance with 

your individual preferences, you have to choose the desired heating 

temperature. Turning the thermostat knob clockwise (from MIN position 

towards MAX position), you thus adjust the temperature mode you need. 

Since the moment you choose the temperature mode (provided one or 

7. UNIT OPERATION RULES AND PROCEDURE

another power mode is activated  see item 4) the oil filled radiator will start 

to operate.
6. During the first minutes of radiator’s operation you may fell a slight smell 

of burning. It may be caused by dust on the unit; it will soon disappear. 

If necessary, you can perform a preliminary preventive cleaning of the 

unit, following rules, set forth in this manual and observing «Important 

precautions».
7. When the room temperature will reach the desired level, you should 

slowly turn the temperature regulator’s knob counterclockwise (towards 

MIN). You will hear a click of the thermostat turning off, and the light on the 

control panel will go out. Now the room temperature will be maintained at 

the chosen level.
8. If you need to reduce the room temperature, turn the thermostat knob 

counterclockwise. Also you can lower the unit’s operating power (I or II).
9. If you need to raise the room temperature, turn the thermostat knob 

clockwise (maximum possible position  MAX indicator). Also you can raise 

the unit’s operating power (II or III).
Pressing the fan heater button, you must select the ON position (switched 

on), upon that power supply will be automatically fed both to the fan motor 

and to the built-in heating element. If you need to turn on the fan heater, 

please, press the button again, selecting the OFF position (switched off).