Hyundai H-HO2-14-UI559 - Инструкция по эксплуатации - Страница 8

7.

Electric oil-illed radiator

EN

3. DISPOSAL

Detailed information on the recycling can be obtained from representative of the local authority.

Service life of the device speciied in the warranty card.

4. ASSEMBLY AND INSTALLATION

1. Unpack the radiator and roller wheels and remove all the packaging material. 

2. Overturn the radiator on a mat or no sot surface, to avoid damage to lacquer coating. 
3. Install wheel plates on the lower part of radiator sections, into two ixed supports. 
4. Draw  up  two  inger  nuts  on  one  side  and  two  inger  nuts  on  the  other  -  in  clamp  extensions 
passed  through  the  wheel  plate  supports,  ater  making  sure  that  2  openings  in  the  wheel  plate 

match together with the clamp extensions. 
5. Turn the radiator back and tip it up.

ATTENTION! 

1. Switch  on  and  operate  the  radiator  only  when  upright  (with 

wheels below and control elements above). Any other position may 

cause  a  dangerous  situation  and  result  in  failure  of  the  oil-illed 

radiator or damage of property and the manufacturer will consider 

this as a non-warranty case. 
2. Do not switch the radiator on, if roller wheels are not installed

ATTENTION! 

The  power  outlet  should  be  rated  at  least  10A  for  models  with  a 

maximum capacity of up to 2000 W and at least 16A for models with 

a maximum capacity of more than 2000 W.

17. Install and operate the appliance only when upright. Do not operate the appliance in the hor

-

izontal or on the slant. 
18. The appliance is not intended for use by handicapped persons (including children) with insuf-

icient experience and knowledge, if they are not under observation or have not been instructed 

in the use of appliance from a person responsible for their safety. Make sure that children do not 
play with the radiator.

5. CONNECTING TO THE MAINS

1. Appliance is designed for connection to the plug with single-phase ~220 V, 50 Hz. 

2. Before connecting, make sure that the voltage is correct as speciied on the nameplate with the 

technical data of the device. 
3. Appliance when connected to the plug must comply with applicable electrical codes. 
4. Electric outlet must be properly grounded. The receptacle must be rated for at least 10A. 
Electrical plug and socket must always be kept dry to prevent electrical leakage. Regularly check 

that the electrical plug is irmly connected to the outlet. Veriication is performed in the following 
order: Insert the mains plug into the socket. Ater half an hour, turn of the radiator and unplug the 

power cord, check with the hand, whether the plug is not heated. 

If the plug is heated to a temperature above  50 °C, in order to avoid damage, accidents, ire, due 

to poor electrical contact replace the socket with help of a specialist.