BRAYER BR4803 - Инструкция по эксплуатации - Страница 9

9

EN

FAN HEATER OSCILLATION MODE

• 

Press the button (9) «ПОВОРОТ» on the control 

panel (3) or the button (16) «

» on the remote 

control (18) to switch the body oscillation mode on, 
the symbol « 

 » will appear in the operation mode 

icons row (11). To switch the oscillation mode off, 

press the button (9) «ПОВОРОТ» or (16) «

» again, 

the symbol 

« 

 » on the control panel (3) will go out.

TIMER SETTING

• 

Press the timer on/off button (8) «ТАЙМЕР» on 

the control panel (3) or the button (15) «

» on 

the remote control (18) and set the requited timer 

operation time, the symbol « 

 » will appear in the 

operation mode icons row (11).

•  Time setting range is up to 12 hours.

•  The timer operation time is indicated with the digital 

symbols (12) on the control panel (3). 

• 

To switch the timer off, consequently press the button 

(8) «ТАЙМЕР» or the button (15) «

» until the 

digital symbols (12) show the room temperature.

ROOM HEATING TEMPERATURE SETTING

• 

Press the buttons (10) «–/+» on the control panel (3) 

or the buttons (17) «–/+» on the remote control (18) 

to set the required room heating temperature.

•  The temperature setting range is from 10 to 35 

degrees, the temperature is displayed on the control 

panel (3) with digital symbols (12).

• 

Switching the fan heater off

• 

Switch the fan heater off by pressing the on/off button 

(6) « 

 » on the control panel (3) or the button 

(13) «   » on the remote control (18).

• 

Note: 

— after pressing the buttons (6,13), the 

heating element will switch off, but the fan will 

continue to operate for 30 seconds to cool the 

heating element.

• 

After the fan stops, switch the power off by setting 

the switch (5) to the position «0».

AUTOMATIC EMERGENCY SWITCH-OFF 

FUNCTION IF THE OUTGOING AIR IS TOO 

HOT

•  If the outgoing air temperature exceeds the 

acceptable value, the automatic thermal switch will 

switch on, and the fan heater will be switched off.

•  Set the power switch (5) to the position «0» and 

unplug the unit, let the fan heater cool down for 

approximately 15-25 minutes (depending on the air 

temperature in the room) and only after that you can 

switch the unit on again.

• 

Make sure that the front (2) and rear grids  are not 

blocked with foreign objects.

• 

Insert the power plug into the mains socket and