BRAYER 2000 Вт BR4802 - Инструкция по эксплуатации - Страница 9

9

EN

remote control (25) and set the requited timer 

operation time, the symbol (15) will appear on the 

display (3).

•  Time setting range is up to 8 hours.

•  The timer operation time is indicated with the digital 

symbols (16) on the display (3). 

• 

To switch the timer off, consequently press the button 

(12) « 

 » or the button (22) «

» until the digital 

symbols (16) show the room temperature.

ROOM HEATING TEMPERATURE SETTING

continue to operate for 30 seconds to cool the 

heating element.

• 

After the fan stops, switch the power off by setting 

the switch (5) to the position «0».

AUTOMATIC EMERGENCY SWITCH-OFF 

FUNCTION IF THE OUTGOING AIR IS TOO 

HOT

•  If the outgoing air temperature exceeds the 

acceptable value, the automatic thermal switch will 

switch on, and the fan heater will be switched off.

•  Set the power switch (5) to the position «0» and 

unplug the unit, let the fan heater cool down for 

approximately 15-25 minutes (depending on the air 

temperature in the room) and only after that you can 

switch the unit on again.

• 

Make sure that the front (2) and rear grids (6) are not 

blocked with foreign objects.

• 

Insert the power plug into the mains socket and 

switch the fan heater on.

• 

If the fan heater does not switch on, it may be caused 

by another malfunction. In this case apply to a 

service center for repairing of the fan heater.

PROTECTION FROM DROPPING

•  If the fan heater accidentally falls or tilts too much, 

the fall protection device will switch on and the fan 

heater will be switched off.

ATTENTION! 

You can set the room heating temperature only with 

the remote control (25).

• 

Press the buttons (23) «

» / « » on the remote 

control (25) to set the required room heating 

temperature.

•  The temperature setting range is from 10 to 35 

degrees, the temperature is displayed on the display 

(3) with digital symbols (16).

• 

Switching the fan heater off

• 

Switch the fan heater off by pressing the on/off button 

(9) « 

 » on the control panel (4) or the button 

(20) « » on the remote control (25).

• 

Note: 

— after pressing the buttons (9 or 20), the 

heating element will switch off, but the fan will