BRAYER 2000 Вт BR4802 - Инструкция по эксплуатации - Страница 8

8

EN

REMOTE CONTROL (25)

• 

Note: 

— the temperature digital indications (16) 

shown on the display (3) may be slightly different 

from the readings of another thermometer.

• 

Switch the fan heater on by pressing the on/off button 

(9) « 

 » on the control panel (4) or the button 

(20) « » on the remote control (25).

• 

Select the operation mode by pressing the button 

(11) « 

 » on the control panel (4) or the button 

(20) « » on the remote control (25).

•  The operation modes are indicated on the display (3) 

with the symbols (17, 18, 19).

• 

Note:

 — when you switch the unit on for the first 

time in the heating mode, some smoke or foreign 

odor may appear. It is normal and not covered by 

warranty.

FAN HEATER OSCILLATION MODE

• 

Press the button (10) « 

 » on the control panel (4) 

or the button (24) «

» on the remote control (25), 

the fan heater oscillation mode will be switched on, 

and the symbol (13) will appear on the display (3). To 

switch the oscillation mode off, press the button (10) 

«   » or (24) «

» again, the symbol (13) on the 

display (3) will go out.

TIMER SETTING

• 

Press the timer on/off button (12) « 

 » on the 

control panel (4) or the button (22) «

» on the 

ATTENTION! 

A lithium battery is used in the remote control. To 

avoid danger, do not allow children to play with the 

battery. 

If your child has swallowed a battery, 

immediately see a doctor. 

BATTERY INSTALLATION/REPLACING (PIC. 1)

• 

Press on the clamp and remove the battery holder 

(26) from the remote

• 

control (25) body, insert a CR2025 battery (not 

supplied with the unit) into the holder, strictly 

following the polarity.

• 

Install the battery holder (26) into the remote control 

(25).

• 

Notes: 

 -

replace the battery in time;

 -

do not recharge the lithium battery;

 -

remove the battery if you are not planning to use 

the unit for a long time;

 -

remove the used battery from the remote control 

and dispose of it.

SWITCHING THE FAN HEATER ON

• 

Insert the power plug into the mains socket.

• 

Switch the fan heater on by setting the power switch 

(5) to the position «I», the symbol (14) will appear 

on the display (3) and the room temperature will be 

displayed with the digital symbols (16).